Panasonic AJ-HDX900P White balance memories, When there is no time to adjust the white balance, When the white balance cannot be adjusted automatically

Chapter 4 Adjustments and settings for recording (continued)

When there is no time to adjust the white balance

Set the WHITE BAL switch to PRST. The white balance for the filter is achieved in accordance with the setting position of the FILTER control (outer).

When the white balance cannot be adjusted automatically

When the white balance adjustment was not completed correctly, one of the following error messages will appear on

the viewfinder screen. When an error message is displayed,4 take the recommended action, and try adjusting the white

balance again. If the error message persists even after repeated attempts, the inside of the unit must be inspected. For details, contact your dealer.

Messages relating to white balance adjustment

Error		Meaning		Recommended action
message
COLOR TEMP.	Color	temperature	is	too Select a suitable filter.
HIGH	high.
COLOR TEMP.	Color	temperature	is	too Select a suitable filter.
LOW	low.
LOW LIGHT	There is not enough light. Increase the amount of light
				or increase the gain.
LEVEL OVER	There is too much light.			Reduce the amount of light
				or reduce the gain.
CHECK FILTER	The setting position of the Check the CC filter selector

CCfilter selector control is control. not correct.

TIME OVER	AWB was not completed The		shooting conditions
	within the allotted time.	may be unstable.		If flicker
		occurs, engage the shutter
		and	shoot again	under
		stable conditions.

White balance memories

The values stored in the memories are retained even after the unit’s power has been turned off until the white balance is next adjusted. There are two sets of white balance memories, A and B.

When ON has been selected (initial setting) as the setting for the FILTER INH item on the <WHITE BALANCE MODE> screen opened from the OPERATION page by performing menu operations, the number of memories is limited to one in A and one in B. In this case, the memory contents are not coupled with the CC filter.

When FILTER INH is set to OFF, the adjustment values for each CC filter can be automatically saved in the memories corresponding to the WHITE BAL switch settings (A or B). This unit contains four filters so that a total of 8 (4a2) adjustment values are saved.

When the S. GAIN function operates, the AWB switch is not activated and is the PRST value of the WHITE BAL switch.

33