Adjusting the Black Balance

The black balance must be adjusted when: You use your unit the first time.

Your unit has not been used for some time.

The ambient temperature has changed substantially. The gain switchover value has been changed. SYSTEM MODE has been changed.

1 Set the switches as illustrated below.

ab

a. AUTO W/B BAL switch:

b. OUTPUT:

Used to perform ABB.

[CAM]

2 Tilt the AUTO W/B BAL switch so that it is positioned at [ABB], then release it.

The switch returns to the central position with the black balance automatically adjusted.

3 During adjustment, the viewfinder displays the following

Notes

Ensure that the lens connector is connected and the lens iris is CLOSE.

During a black balance adjustment, light is automatically cut off.

During a black balance adjustment, the gain switchover circuit is automatically switched. The viewfinder screen may flicker and/or display noise; this is not a failure.

If you find the black shading annoying after performing an auto black balance adjustment, adjust the black shading. To do so, go to the menu option DETECTION (DIG), move the cursor (), then press the jog dial button.

The menu option DETECTION (DIG) can be found in the <BLACK SHADING> screen on the MAINTENANCE page.

Note that pressing the ABB switch for longer than 8 seconds automatically performs an auto black balance adjustment, followed by an automatic black shading adjustment. (See the menu option SHD.ABB SW CTL in [SW MODE] (page 193).)

However, when the remote control unit (AJ-RC10G, optional) is connected, automatic black shading cannot be executed even if the ABB switch is held down.

To cancel the automatic black balance adjustment in process (the viewfinder displays “ABB ACTIVE”), flip the AUTO W/B BAL switch down to [ABB] again.

If automatic adjustment is canceled, the value in effect before automatic adjustment will be used.

Recording for Settings and Adjustments

message:

 

Retaining black balances

 

 

 



Each value in memory is retained even if the unit is turned

 

off.

Note

During adjustment, the lens iris automatically becomes

CLOSE.

4 The adjustment will take effect in a few seconds and the following message will appear:



The adjusted value is automatically stored in the memory.

Adjustments and Settings for Recording: Adjusting the White balance and Black Balance

55