GAIN, Auto Iris, Iris Level 0 to | Panasonic AK-HC1500G instruction

Setting of menu items

ENGLISH

MAINTENANCE menu

[8]GAIN, AUTO IRIS

�� GAIN,AUTO IRIS ��

LOW GAIN	:0dB
MID GAIN	:9dB
HIGH GAIN	:18dB
A.IRIS LEVEL	:050
A.IRIS PEAK/AVE	:050
A.IRIS WINDOW	:NORM1
IRIS MODE	:LENS
IRIS GAIN	:05

LOW GAIN [–6 dB to 30 dB]

MID GAIN [–6 dB to 30 dB]

HIGH GAIN [–6 dB to 30 dB]

For setting the amount by which the gain is to be increased when LOW, MID or HIGH has been selected by GAIN SELECT.

A.IRIS LEVEL [0 to 100]

For adjusting the target level (brightness) of the auto iris.

A.IRIS PEAK/AVE [0 to 100]

For setting the ratio between the auto iris light-metering peak value and average value.

A.IRIS WINDOW [NORM1, NORM2, CENTR] For setting the auto iris light-metering area.

NORM1: The light is metered on the entire screen (except around the edges).

NORM2: The light is metered on the entire screen (except at the top).

CENTR: The light is metered only in the area at the screen center.

IRIS MODE [LENS, CAM]

For switching between the iris gain control on the lens (LENS) and the menu (CAM) to adjust the focusing speed of the auto iris.

Normally, LENS is selected, and the speed is adjusted using the iris gain control on the lens.

IRIS GAIN [01 to 10]

For adjusting the iris gain when CAM has been selected as the IRIS MODE setting.

- 30 (E) -

Image 31

Panasonic AK-HC1500G GAIN, Auto Iris, Iris Level 0 to, Iris PEAK/AVE 0 to, Iris Mode LENS, CAM, Iris Gain 01 to

Contents

Multi Purpose Camera AK-HC1500G FCC Note English Version English Important Safety Instructions For business users in the European Union Accessories Contents Introduction Characteristics  Cooling fan Precautions for use Bottom view Rear view Front view Major operating controls and their functions  HD SDI output connector HD SDI OUT  Tally output connector Tally OUT Iris control cable to Iris connector How to set the lens Configuration example 1 Connection of camera controller How to set up the system Configuration example 2 High-Speed P/T system Start shooting Operation procedureAdjust the white balance Adjust the black balance Auto iris power zoom lens How to adjustFlange back adjustment for zoom lens Lens iris gain volume adjustment Color temperature and white balance adjustment reference White balance adjustment Gen-lock adjustment Black balance adjustment TOP menu Setting of menu itemsHow to display the menus  Using AK-HRP150G camera controller Correctdig OFF, on  Maintenance menuBlack Shading Detection READY, Active Gamma PEDESTAL, Gamma Cine Gamma Select Video REC, Film REC Gamma OFF, onBlack Gamma OFF, on DRS OFF, on Flare 000 to FlareFlare OFF, on Knee Point -25.00% to +25.00% KNEE, White ClipKnee Point 80.00% to 107.00% Video Menu 30% to 90% Film MENU/VIDEO REC Knee Level 100% to 109% Knee Point 80.00% to 107.00%White Clip LVL 90% to 109% High Color OFF, on B GainKnee OFF, MANUAL, Auto White Clip OFF, on Detail OFF, on DetailKnee Aperture OFF, on Detail Source Slim Detail OFF, on Skin Tone DTL OFF, on Skin Tone DetailSkin GET OFF, on Iris PEAK/AVE 0 to Iris Mode LENS, CAMGAIN, Auto Iris Iris Level 0 to Super Gain Mode S.GAIN1, S.GAIN2, S.GAIN3 35 to 0.75 DRS OFF -10 to +10 DRS on Peak Frequency 0 toPED Offset -200 to +200 Frame Rate Range 60-6 Frame ModeFrame Rate 60 to Matrix Table A, B Matrix Color Correction LOW, MID, HIGH, S.GAIN1 to  Setting menuMode Gain Select BAR SEL Matrix Table OFF, A, BColor Correction OFF, on Digital Extender OFF, on AWB OK FormatStatus OFF, on AWB Active FAN OFF, AUTO, on ABB OKOUT Range RGB Menu on BAR OFF, on Shutter Speed ShutterSynchro Scan Auto Detection GEN-LOCKPIX Defect GEN-LOCK Input BNC, Dsub Protocol 1 to Protocol  Camera ID menu Execute Mode LOAD/STORE File Operation menu LOAD/STORE from Preset Reset Time Code menu Menu list 47 E 48 E Unit inch mm Appearance Input/output signal Specifications Control cable for information camera Appendix