Panasonic AW-DU600P manual $ Dial memory

Menu settings

The following items are only displayed when this adapter is in Direct mode

	This setting selects which connector is to be used for the controller when this adapter is in Direct mode.
Menu-4 Input
	RS-232C		TO RCB/PC connector (PC used for control)
(Initial setting:RS-232C)
	RS-422		PAN/TILT CONTROL IN connector (control panel used for control)
	This setting selects which pan-tilt head system is to be controlled by this adapter when this
	adapter is in Direct mode.
	P1	The pan-tilt head system connected to the RS-232C or RS-422 P1 connector is
		controlled.
	P2	The pan-tilt head system connected to the RS-232C or RS-422 P2 connector is
Menu-6 Output-2		controlled.
(Initial setting: P1)
	P3	The pan-tilt head system connected to the RS-232C or RS-422 P3 connector is
		controlled.
	P4	The pan-tilt head system connected to the RS-232C or RS-422 P4 connector is
		controlled.
	P5	The pan-tilt head system connected to the RS-232C or RS-422 P5 connector is
		controlled.
The following item is only displayed when this adapter is in Rx mode or Direct mode
	This setting selects which connectors are to be used for the pan-tilt head systems.
			The RS-232C CONTROL OUT connectors are used.
Menu-5 Output-1	RS-232C		The RS-422 connectors cannot be used in conjunction with these
			connectors.
(Initial setting: RS-422)
			The RS-422 CONTROL OUT connectors are used.
	RS-422		The RS-232C connectors cannot be used in conjunction with these
			connectors.

$ Dial memory

This adapter’s dial memory function enables up to 5 specific telephone numbers to be stored.

O Registering a telephone number

1.Enter the number using the operating keys on this adapter.

2.While pressing the # key, press one of the dial memory registration keys from 1 (M1) through 5 (M5) into which the number is to be entered.

3.“Writing Memory 2” (2 is the dial memory number) appears on the LCD panel and the telephone number is stored.

O Using a dial memory to make a call

1. Press the RECALL key ( # i STOP ).

2.The dial memory number (M1 to M5) entered appears on the LCD panel.

If a telephone numbers has not been registered for the dial memory number, the LCD panel display will be blank.

3.Each time the RECALL key ( # i STOP ) is pressed, the dial memory number is switched.

4. Press the START key to initiate the connection.

O Erasing a dial memory

1.Press the CLEAR key ( # i START ) to erase the number displayed on the LCD panel.

2.While pressing the # key, press one of the dial memory registration keys from 1 (M1) through 5 (M5) which is to be erased.

3.“Writing Memory 2” (2 is the dial memory number) appears on the LCD panel and the telephone number is erased.

18