Installation
Assembling the pan-tilt head
When assembling the
Attaching the camera mounting base
Attach the camera mounting base to the rotary arm using the three mounting screws (M522 mm, with flat washers, spring washers) provided. The installation direction differs depending on how the base is installed.
Attaching the rotary arm
Attach the rotary arm to the rotary head using the four mounting screws (M522 mm, with flat washers, spring washers) provided. The installation direction differs depending on how the arm is installed.
For a stand-alone installation
Rotary head
Camera mounting base
Rotary arm
For installation on the ceiling
Change the guide pin and screw positions as shown in the figure below on the right, and then attach the camera mounting base to the rotary arm.
Camera Mounting base
Change the positions of the guide pins.
Rotary arm
Change the positions of the camera mounting screws.
Camera mounting base
Rotary head
11