Installation Guide
Network Camera Indoor Use Only
•Please read the Important Information before using.
•"Network Camera" is called "Camera" in this manual.
Model No. BB-HCM381 BB-HCE481
(AC Adaptor Type)
(PoE Type)
•
•
"Setup
The illustrations used in this manual are of
This manual is for both
Mount the camera after the camera is connected and finished setting up following Getting Started.
Installation Procedures
Temporarily place the camera.
Adjust the position and direction of the camera.
Attach the camera.
Temporarily place the camera where you like to view images.
Adjust the position and direction of the camera while you confirm that images are displayed on the monitor as you imaged.
The camera can be mounted on the ceiling.
Attach the camera firmly when mounting on the ceiling.
•The camera can be viewed in the least light requirement at 3 lx (default). Use supplemental lighting for the dimly lit places. (The camera can be viewed in the least of 0.09 lx in the color night view mode (see page 86 of the Operating Instructions on the
•After preparing the Ethernet cable that has enough length, mount the camera.
•Mounting and cabling instructions described in this Installation Guide follow generally accepted guidelines suitable for residential installations. In some areas, commercial and industrial installations are regulated by local or state ordinances. For such installations, contact your local building department or building inspector for more details.
Mounting on the Ceiling
•Make sure the camera is firmly mounted on the ceiling.
•The camera is available between ±15˚ based on level line for mounting.
•The camera should be uninstalled from the ceiling when removing the SD memory card (see page 146 of the Operating Instructions on the
•The camera is intended for indoor use only. Prolonged exposure to direct sunlight or halogen light may damage CCD.
•The camera's MAC address and serial number are printed on the bottom of the camera. They are needed in order for camera configuration and maintenance. Record both of them for before mounting the camera.
•Set the Mounting type setting to [On the ceiling] on the Camera Setup page (see page 86 of the Operating Instructions on the
•Two ways of wiring can be considered; wiring through a hole made in the ceiling or wiring without making a hole for a cable in the ceiling. Select either one of the two.
•The audio cable or audio/video cable cannot be connected or removed after mounting on the ceiling.
Wiring through a hole made in the ceiling
1 Attach the Ceiling Plate B on the ceiling with Screws B.
Keep more than 100 mm
off the wall or other obstacles.
Camera direction
100 mm
Screws B (4 pcs.)
•Attach the Ceiling Plate B more than 100 mm off the wall or other obstacles from its center.
•Make sure the camera is firmly mounted on a beam of wood etc. When there is no beam, apply a board on the other side of the ceiling to make sure the camera does not drop.
© 2006 Panasonic Communications Co., Ltd. All Rights Reserved. | PQQX15195ZA KK0306JT0 (CE) |
