How to Attach the Rack mounting
If you use
1.Remove the screws on the back and base of the monitor (3 places), and remove the stand.
Rear view
2.Using the screws provided, attach the rack- mounting adaptors to both sides of the monitor.
Stand
Screw
Base
Screw
Error/Warning Displays
If for any reason an error occurs in this monitor, the LEDs above the picture adjusting knob flash at
Error/Warning | Symptom | Solution | |
displays | |||
|
| ||
Inverter error | If a malfunction occurs in the inverter that | Switch the power supply OFF once, then | |
| controls the backlight brightness, the | switch it back ON again. If an error is still | |
| backlight will switch OFF. | displayed, contact the vendor where you | |
| The screen becomes completely black. | purchased the monitor. | |
|
|
| |
Fan stop | The fan in the back of the monitor stops if | If the error is still displayed after this, | |
Error | a malfunction occurs. If a picture is being | contact the vendor where you purchased | |
| displayed when the malfunction occurs, it | the monitor immediately. | |
| will continue being displayed as is. | If a fan stop error occurs, setting “FAN | |
|
| MOTOR” to “OFF” in the “SYSTEM | |
|
| CONFIG” menu (refer to page 18) allows | |
|
| you to continue using the monitor with | |
|
| reduced screen brightness. | |
|
|
|
Maintenance
•To clean the cabinet or surface of the liquid crystal protection panel, gently wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a weak detergent solution and then
•Never use thinner or benzene to clean this unit.
Doing so would cause the surface of the monitor to become discolored, and cause paint to peel.
•Do not spray cleansers directly onto the monitor.
Water or similar substances getting inside the monitor can cause a malfunction.
27