Introduction
The
∫ Wide angle of view | ∫ Functions |
By using an LCD screen with a wide angle of view, exceptional image visibility is assured across wide angle ranges in both the
This monitor is equipped with a
∫Color temperature, gamma correction
The color temperature complies with the D65 and D93 standards while gamma correction is set to the 2.2 curve.
∫REMOTE connector
This enables parallel remote input control which in turn makes it possible to select functions.
∫Mode settings
Users can choose between three modes: the image pro- duction mode (BROADCAST), the general user image- receiving mode (GENERAL), and the user setting mode (USER).
Parts and their functions (front panel)
83 SCAN button
UNDER SCAN: At this setting, signals in the video signal standard area can be viewed.
| OVER SCAN: This setting provides overscanning of | |
| around 8% so that about 85% of the | |
7 | video signal standard area is | |
displayed. | ||
| ||
| Overscanning displays are used by consumer products | |
| although their scanning ratio differs from product to | |
| product. |
POWER | MENU/ | ENTER |
INPUT SCAN BLUE | EXIT |
MENUVOLUME
1 2 4 5 6
3
1Power switch
This is the main power switch.
When the power is ON, the LED (green) above the switch lights.
2INPUT selector button
This is used to select the signal input, and each time it is
pressed, the input is switched in the following sequence:
LINE A > LINE B > CMPNT> SDI > LINE A.
<Note>
The SDI signal input can be selected only when the BT- YA210G, available as an optional accessory, is installed.
4BLUE ONLY button
The chroma and phase can be adjusted more accurately using SMPTE color bars when this button is pressed.
5MENU selector buttons
These are used to display the menus and perform the adjustments and settings.
MENU/EXIT: Press this button to exit the menu display and menu. Further, if this button is pressed after the menu item has been selected, the menu will be exited with the item entered.
WX: Press these buttons to move the cursor up or down or to select menu items.
ENTER: Press this button to select menu items or enter settings.
6Volume controls
The volume level is altered by pressing the up (W) and down (X) buttons.
7Speaker
8Tally lamp
The lamp (red) lights due to remote control operation. See “REMOTE specifications” (page 10) for details.
5