Panasonic BTT268 Preparing the speakers, Positioning, Preparing cables and making connection,  

STEP 1 : Preparing the speakers

Preparing cables and making connection

∏ 5 Speaker cables

(REEX1266A: RED)

(REEX1267A: WHITE)

(REEX1268: GREEN)

(REEX1269: GRAY)

(REEX1270: BLUE)

1 Use of the speaker cable stickers is convenient when making cable connections.

e.g. Front speaker (L)

FRONT

Lch





ASpeaker cable sticker (supplied)

B Connector

Speaker cable sticker		Color
1	FRONT (L)	WHITE
2	FRONT (R)	RED
3	SURROUND (L)	BLUE
4	SURROUND (R)	GRAY
5	CENTER	GREEN
6	SUBWOOFER	PURPLE

Be sure to match the number on each sticker with the connector color.

2 Connecting the speaker cables. Insert the wire fully, taking care not to insert beyond the wire insulation.

e.g. Surround speaker

r: White

s: Blue line

Push!

≥Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers.

≥Don’t use a front speaker as a surround speaker or vice versa. Verify the type of speaker with the label on the rear of the speaker before connecting the appropriate cable.

≥To avoid injury by falling or dropping the speaker, place the speaker cables with care not to stumble or hook.

≥Do not hold the speaker in one hand to avoid injury by dropping the

VQT3M40 speaker when carrying.

STEP 2 : Positioning

Caution

≥The main unit and supplied speakers are to be used only as indicated in this setup. Failure to do so may

lead to damage to the amplifier and/or the speakers, and may result in the risk of fire. Consult a qualified service person if damage has occurred or if you experience a sudden change in performance.

≥Do not attempt to attach these speakers to walls using methods other than those described in this manual.

≥Do not touch the front netted area of the speakers. Hold by the sides.

How you set up your speakers can affect the bass and the sound field.

Setup example

Place the front, center and surround speakers at approximately the same distance from the seating position. The angles in the diagram are approximate.

≥Keep your speakers at least 10 mm (13/32z) away from the system for proper ventilation.





60°



120°



ACenter speaker

≥Put on a rack or shelf not to interfere with the TV's various sensors (ambient light, etc.). Vibration caused by the speaker can disrupt the picture if it is placed directly on the TV.

BFront speakers C Subwoofer

D Surround speakers

≥Place the speakers at the same height or higher than ear level.

≥Use only supplied speakers

Using other speakers can damage the unit, and sound quality will be negatively affected.

≥You can damage your speakers and shorten their useful life if you play sound at high levels over extended periods.

≥Positioning speakers in front

It is possible to locate all the speakers in front of the listening position. However, the optimal surround sound effect may not be obtainable.

≥Place speakers on flat secure bases.

≥Placing speakers too close to floors, walls, and corners can result in excessive bass. Cover walls and windows with thick curtains.

≥For optional wall mount, refer to page 36.

∫If irregular coloring occurs on your TV,

turn the TV off for about 30 minutes.

If it persists, move the speakers further away from the TV.

10