28
Troubleshooting
11 After the reinstallation procedure completes, this
screen should appear.
12 Remove the recovery CD and press any key to shut
down the computer, then remove the CD drive.
13 Turn the computer on, and press F2 while [Panasonic]
screen is displayed.
The Setup Utility will start up.
If the password has been set, enter the Supervisor Pass-
word.
14 Press F9 .
At the confirmation message, select [Yes] and press
Enter . (The Setup Utility settings will return to their
default values. Even the security settings with the ex-
ception of the password(s) will return to their default
values.)
15 Press F10 .
At the confirmation message, select [Yes] and press
Enter .
16 Perform the setup procedure for Windows by following
the instructions on the screen ( page 11).
17 Install the Acrobat Reader ( page 13).
18 Run the Setup Utility and change the settings where nec-
essary.
Do not interrupt the reinstall procedure before
completion, for example by turning off the com-
puter or pressing Ctrl + Alt + Del , as this
may prevent Windows from starting up, or may
cause data to be lost so that the reinstall procedure
cannot be executed.
When a message appears instructing you to insert
the next CD, insert the recovery CD showing the
next number in the sequence, and then select [OK].
If the message “The media does not contain the cor-
rect file” appears, select [OK]. A message will ap-
pear instructing you to insert the next CD.
Confirm that the proper recovery CD has been in-
serted by opening the cover of the CD drive and
then close the cover, then select [OK].
CAUTION
Reinstalling Software
--------------------------------------------------------------------------
[Recovery] is complete.
Windows(R) XP Professional install wizard will start after reboot.
After turning off the power, please disconnect the CD/DVD-ROM drive, and
turn the power on again.
--------------------------------------------------------------------------
Windows XP
Windows 2000
--------------------------------------------------------------------------
[Recovery] is complete.
Windows(R) 2000 Professional install wizard will start after reboot.
After turning off the power, please disconnect the CD/DVD-ROM drive, and
turn the power on again.
--------------------------------------------------------------------------