16
Operation
1Open the display.
Starting Up/Shutting Down

Starting Up

Slide the latch located at the front.
Lift open the display.
2
1
CAUTION
Do not open the display wider than necessary (160° or more).
Do not apply excessive pressure to the LCD. Also, do not hold the LCD
when opening or closing the display.
Latch
2
1
Three incorrect attempts
or
No password for about a minute*2
The correct password
Will Start
Enter your password*1 and press Enter . ( “Security Measures”)
Will Not Start
(Power off)
If [Enter Password] is displayed
*1Supervisor Password or User Password set in the Setup Utility (not
the Windows password).
*2If the setup utility has been started up, the power will not be turned
off even after one minute has passed.
Enter Password [ ]
2Turn your computer on.
Slide the power switch and hold it for approximately one second until the power
indicator turns on before releasing it.
CAUTION
While booting, avoid the following until the hard disk drive indicator ( )
has turned off.
• Connecting or disconnecting the AC adaptor.
• Touching the power switch.
• Performing any keyboard, touch pad, or external mouse operations.
• Closing the display.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
When the CPU temperature rises, the computer may not power on to pre-
vent the CPU from overheating. Should this happen, allow the computer to
cool down then switch the power on again.
If the computer still does not power on, contact your technical support office.
( page 33)
When an application or file that was previously displayed
appears on your screen
The standby or hibernation mode has been set ( “Standby/Hibernation Func-
tions”).
Power Switch
Power Indicator