Panasonic CQ-R221U manual TPS Operation Tape Program, Search

E N G L I S H

7

Cassette Tape Player Basics continued

	TPS Operation (Tape Program
	Search)
	Press [3] (TPS) to activate the tape program search mode.
d	From the current selection, decide which program you want to
	select. Now, press [	] several times forward (up to 9
	programs) or press [	] several times backward (up to 8 ) to
	select the corresponding program number.

S•HD

or

S•HD

	(Rewind:)	(Fast forward:)
8	0	1	9
	c	c

EX1. To select the current program again press [3] (TPS), and press

[	] once.
EX2. To	select the 1st	program
backward of the current selection,
press [3] (TPS) once,		and press
[	] two times.

EX3. To select the next program, press [3] (TPS) and press [ ] once.

EX4. To select the 3rd program forward of the current selection, press [3]

(TPS) once, and press [	]
three times.
To turn it off, press [3] (TPS) again.

Note:

The TPS mode may not work correctly in the following cases. This, however, does not mean that the unit is defective.

●There is an interval less than 4 seconds or having a high level of noise or hum between programs.

●There is particularly low-level passage during the program.

Notes on Cassette Tapes
Pencil
Tape Slack:
Use a pencil or similar object to take up the slack
as shown. If a loose tape is used, this may result
in the tape becoming tangled in the rotating
parts of the unit.	Do not touch
	or pull out
	the tape.

Notes:

●To maintain your cassette player in top condition, avoid using tapes that are longer than 90 minutes (C-90).

●If you insert into the unit a cassette with a loose tape caused by forcing it into cassette with a finger or the like, the cassette may not be properly reproduced. In such a case, eject the cassette, make the tape tight, then insert it back into the deck.

16

CQ-R221U