E |
| Electrical Connections | Speaker Connections | |||||||
N |
| |||||||||
G |
| |||||||||
L |
|
|
|
|
|
|
|
|
|
|
Preparation: |
|
|
|
|
|
|
|
| ||
I |
|
|
|
|
|
|
|
|
| |
S |
| • This unit can be connected to an optional CD changer |
|
|
|
|
|
|
|
|
H |
|
| Caution: Please follow the instructions given below. Failure to do so will cause damage to the unit and speakers. | |||||||
| • For connection to a CD changer, refer to the operating instructions of the CD Changer |
| ||||||||
14 |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
|
| Caution: |
|
|
| <Right> | • Use ungrounded speaker only. | |||
|
|
|
|
| ||||||
|
|
|
|
|
| (White) | • The maximum speaker input should be 45 W or more. (If used with the optional | |||
|
| • This product is designed to operate with a 12 V DC, negative ground battery system. |
|
|
|
| ||||
|
|
| L | + |
|
| + | power amplifier, the speaker input should be higher than the maximum amplifier | ||
|
|
|
|
|
| - | ||||
|
| • To prevent damage to the unit, be sure to follow the connection diagram below. |
|
| - |
| (White | output.) | ||
|
| • Strip about 5mm of the lead ends for connection (only |
|
|
|
| w/black stripe) | |||
|
|
|
|
|
| • The speaker impedance should be 4 - 8 Ω . | ||||
|
| • Do not insert the power connector into the unit until the wiring is completed. |
|
|
|
|
|
|
| |
|
|
|
| + |
| (Gray) | • This unit uses the BTCL circuit, so each speaker should be connected separately | |||
|
| • Be sure to insulate any exposed wires from a possible |
|
|
| |||||
|
|
| R |
|
| + |
| |||
|
|
|
|
|
| |||||
|
| keep cable terminals free from touching any metal parts. |
|
| - |
|
| - | using parallel vinyl insulated cords. | |
|
|
|
|
|
| |||||
|
|
|
|
|
| (Gray | ||||
|
|
|
|
|
| • The speaker cords and the power amplifier unit should be kept away (about 30 cm | ||||
|
| • Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased when |
|
|
|
| w/black stripe) | |||
|
|
|
|
|
|
|
|
|
|
the battery terminals are disconnected. | apart) from the antenna and antenna extension cord. |
|
E
N
G
L
I
S
H
15
❐ Wiring Diagram
Extension Cord
Supplied for an optional CD Changer (DIN/BATT/RCA/GND)
CD Changer
(option)
Ground Lead
To a clean, bare metallic part of your car
<Wrong>
L | + | + |
- | - |
| Chassis | |
+ |
| + |
L | + | + | L | + | + | + |
- | - | - | - | - | ||
| + | + |
| + | + | + |
Fuse(3A)
BATTERY
RCA Cord
DIN Cord
(L)
(White)
(Red)
(R)
Battery Lead
To the car battery, continuous +12V DC
CD Changer
Control Connector
R - | - |
Chassis
•Never connect the speaker cord to the body of the car.
R - | - | R - | - | - |
• Do not use a | • Do not connect more than one |
system having a common earth | speaker to one set of speaker |
lead. | leads. |
Fuse (15 A)
L(White)
R(Red)
Antenna
White
Left
White/black stripe
Front
Gray
Right
Gray/black stripe
Green
Left
Green/black stripe
Rear
Violet
Right
Violet/black stripe
Front speaker lead
FRONT SP |
Rear speaker lead
REAR SP |
Power Connector
Blue/white stripe
Blue
Black
BATTERY 15A
Yellow
ACC
Red
External amplifier control power lead
Not Used
Ground lead
(To a clean, bare metallic part of the car chassis.)
Battery lead
(To the car battery, continuous +12 V DC)
ACC power lead
(To ACC power, +12 V DC)
Fuse
Use fuses of the same specified rating (15 A). Using different substitutes or fuses with higher ratings, or connecting the unit directly without a fuse, could cause fire or damage to the unit.
If the fuse replacement fails, contact your nearest authorized Panasonic Service Center.
Maintenance
Your product is designed and manufactured to ensure the minimum of maintenance. Use a soft cloth for routine exterior cleaning. Never use benzine, thinner, or other solvents.
18 |
| 19 | ||
|
|
| ||
|
|
|
|
|