E N G L I
Installation
E N G L I
S
H
10
Preparation
•Before installation, check the radio operation with antenna and speakers.
•Disconnect the cable from the negative
•Unit should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30°.
30˚ or less
Caution: Do not disconnect the battery terminals of a car with trip or navigational computer since all user settings stored in memory will be lost. Instead take extra care with installing the unit to prevent shorts.
Dashboard Installation
Installation Opening
The unit can be installed in any dashboard having
an opening as shown at right. The dashboard
should be 4.5 mm - 6 mm thick in order to be able to support the unit.
Installation Precautions
Installation Hardware
No. | Item | Diagram Q’ty |
q Mounting collar | 1 | |
w Hex. nut (5 mmø) | 1 | |
e Rear support strap | 1 | |
r | Tapping screw | 1 |
(5 mmø ⋅ 16 mm) | ||
t Mounting bolt (5 mmø) | 1 | |
y Power connector | 1 | |
u Dismounting plate | 2 | |
i Trim plate | 1 | |
Cautions:
•We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
•When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your hands and fingers.
First complete the electrical connections, and | Insert Mounting Collar q into the | |
then check them for correctness.(a page 18) | dashboard, and bend the mounting | |
The included Mounting Collar | 1 tabs out with a screwdriver. |
|
q is designed specially for this |
|
|
unit. Do not use it to attach any | The tabs to be bent vary depending on the car. | |
other model. | To securely install the unit, fully bend a | |
| number of the tabs so that there is no rattling. | |
| Example: | Tab |
|
| |
| q Mounting |
|
| Collar |
|
y Power Connector |
|
|
Mounting Holes
t Mounting Bolt
S
H
11
This product should be installed by a professional installer, if possible.
In case of difficulty, please consult your nearest authorized Panasonic Service Center.
1.This system is to be used only in a
2.Follow the electrical connections carefully (a page 18). Failure to do so may result in damage to the unit.
3.Connect the power lead (red) after all other connections are made.
4.Be sure to connect the battery lead (yellow) to the positive terminal (+) of the battery or fuse block (BAT) terminal.
5.Insulate all exposed wires to prevent short circuiting.
6.Secure all loose wires after installing the unit.
7.Please carefully read the operating and installation instructions of the respective equipment before connecting it to this unit.
Mounting Springs (C)
Engage the Mounting |
|
Springs (C) in the | Mounting |
mounting holes of the | |
Mounting Collar q | Hole |
firmly. |
|
Mounting Spring |
|
2
3
4
After fixing Mounting Bolt t and Power Connector y, fix the rear of the unit to the car body by either method (a) or (b) shown on the previous page.
Insert Trim Plate i.
After installation reconnect the negative
14
15
