Electrical Connections | Specifications |
E N G L I S
Caution:
19≥This product is designed to operate with a 12 V DC, negative ground battery system.
≥To prevent damage to the unit, be sure to follow the connection diagram below.
≥Remove approximately 5 mm of protective covering from the ends of the leads before connecting.
≥Do not insert the power connector into the unit until the wiring is completed.
≥Be sure to insulate any exposed wires from a possible
≥Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased when the battery terminals are disconnected.
❐ Wiring Diagram | Supplied hardware | No. | Item | Q’ty |
|
|
|
|
|
|
| 6 | Power connector | 1 |
|
|
|
|
|
❐ General
Power supply: | 12 V DC (11 Vj16 V), test voltage 14.4 V, negative ground |
Current consumption: | Less than 2.2 A (CD play mode; 0.5 Wa4 channels) |
Maximum power output: | 45 Wa4 channels at 400 Hz, volume control maximum |
Tone adjustment range: |
|
Bass: | n12 dB at 100 Hz |
Treble: | n12 dB at 10 kHz |
Suitable speaker impedance: | 4j8 ≠ |
Preamp output voltage: | 2.0 V (CD play mode; 1 kHz, 0 dB) |
Output impedance: | 200 ≠ |
Dimensions (WaHaD): | 178a50a150 mm |
Weight: | 1.4 kg |
❐ FM Stereo Radio |
|
H
20
CD changer CX-DP88
| DIN extension cord (DIN/BATT/RCA/GND) |
|
|
| |||
| (Yellow) Fuse (3 A) | Battery lead |
|
|
| ||
|
|
|
|
|
| ||
(Black) | Changer control DIN cord |
|
|
|
| ||
|
|
|
|
|
|
| |
Ground lead | RCA cord | L (White) |
|
|
|
| |
Be sure to connect to a well |
|
|
|
| |||
grounded metallic part of your car | R (Red) |
|
|
|
|
|
|
because noises or troubles may |
|
|
|
|
|
| |
|
|
|
|
| |||
occur. |
|
|
|
| |||
|
|
|
| CD changer control connector | |||
|
| L (White) |
|
|
|
| |
Antenna |
| R (Red) |
|
|
|
|
|
|
|
|
|
|
|
| |
Preamp out connector (rear) |
| 6 Power connector |
|
| |||
CD changer input connector |
|
|
|
|
| ||
Ground lead |
|
|
| BATTERY 15A | Battery lead | ||
To a clean, bare metallic part of car |
| (Black) | (Yellow) | Fuse (15 A) | To the car battery, | ||
chassis. |
|
|
|
|
| continuous +12 V DC | |
Motor antenna relay control lead |
|
| ACC |
| Power lead | ||
(To motor antenna) | (Max. 500 mA) | (Dark blue) (Red) | Resistor (1 k≠) | To ACC power, | |||
This lead is not intended for use with |
|
|
|
| +12 V DC |
| |
switch actuated power antenna. |
|
|
|
|
|
| |
Amp. relay control power lead |
|
|
|
|
|
| |
This lead is for connection to the power |
|
| Speaker lead |
|
| ||
amplifier. |
|
|
|
|
| ||
|
| FRONT SP | REAR SP |
|
|
| |
|
|
|
|
|
| ||
(White/black | (White) (Gray/black | (Gray) | (Green/black | (Green) (Violet/black | (Violet) | ||
stripe) | stripe) | (s) | (r) | stripe) | stripe) | (s) | (r) |
(s) | (r) | (s) | (r) | ||||
Frequency range: | 87.50 MHzj108.00 MHz |
Usable sensitivity: | 11.0 dBf. (1.25 ¨V, 75 ≠) |
50 dB quieting sensitivity: | 15.2 dBf. (1.6 ¨V, 75 ≠) |
Frequency response: | 30 Hzj15 kHz (n3 dB) |
Alternate channel selectivity: | 75 dB |
Stereo separation: | 42 dB (1 kHz) |
Image response ratio: | 75 dB |
IF response ratio: | 100 dB |
Signal/noise ratio: | 70 dB |
❐ AM Radio
Frequency range: | 531 kHzj1 602 kHz |
Usable sensitivity: | 28 dB/¨V (25 ¨V, S/N 20 dB) |
❐ CD Player
Sampling frequency: | 32 times oversampling |
DA converter: | MASH·1 bit/4 DAC system |
Error correction system: | Panasonic super decoding algorithm |
Astigma | |
Light source: | Semiconductor laser |
Wave length: | 780 nm |
Frequency response: | 20 Hzj20 kHz (n1 dB) |
Signal/noise ratio: | 96 dB |
Total harmonic distortion: | 0.01 % (1 kHz) |
Wow and flutter: | Below measurable limits |
Channel separation: | 75 dB |
Note:
≥Specifications and the design are subject to modification without notice due to improvements in technology.
Left speaker | Right speaker | Left speaker | Right speaker |
(Front) | (Front) | (Rear) | (Rear) |
28 |
| 29 | ||
|
|
| ||
|
|
|
|
|
