E
N
G
L
I
S
H
10
CQ-DF202W 19
E
N
G
L
I
S
H
9
CQ-DF202W
18
Troubleshooting (Continued)

❐Radio

Much noise in FM stereo
and monaural broad-
casts.
Station is too far, or signals are too weak.
➡Select other stations of higher signal level.
Battery cable is not correctly connected.
➡Connect the battery cable to the terminal that is always active.
Preset station is reset.
Trouble Cause/Step
The motor antenna relay control lead is not connected correctly.
➡If there is a motor antenna in the car, connect the motor antenna
relay control lead to the motor antenna lead that is installed in the
car correctly.
The radio antenna is not extended enough.
➡Extend fully the radio antenna.
≥Disc is dirty.
≥Disc has scratches.
➡Clean disc, referring to the section on “Notes on CD/CD Media (CD-
R, CD-RW)”.
Sound skips, bad sound
quality. (e.g. caused by
noise)
Disc is in the CD com-
partment but no sound is
made, or disc is ejected
automatically.
Disc is upside down.
➡Place disc in the correct direction with the label side up.

❐CD

≥Disc is dirty.
≥Disc has scratches.
➡Clean disc, referring to the section on “Notes on CD/CD Media (CD-
R, CD-RW)”.
Trouble Cause/Step
A disc that has data other than CD-DA type is loaded.
➡Discs that have CD-DA type data should be used.
➡The unit may not successfully play back a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive)
and a disc which are incompatible one another. Refer to instruc-
tions for the concerned devices for details.
➡The unit may not successfully play back a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive)
and a disc which are incompatible one another. Refer to instruc-
tions for the concerned devices for details.
≥Disc is defective.
≥Mechanical trouble.
➡Press [OPEN] to open the panel and press [<] (eject). If normal op-
eration is not restored, call the store where you purchased the unit
or the nearest service station to ask for repairs.
Disc is not ejected.

❐CD (Continued)

The first track of a mix mode disc was reproduced. (Mix mode is a for-
mat in which data except music is recorded on the first track and music
data is recorded on other than the first track in a session.)
➡Play back music data recorded on other than the first track.
Time is counted but no
sound comes out.
No sound from left,
right, front or rear
speakers.
Left and right balance, or front and rear balance is off on one side.
➡Adjust balance/fader setting as appropriate.
Cables are not correctly connected.
➡Connect the cables correctly.

❐Sound Setting

The right speaker wire is connected to the left speaker and the left
speaker wire to the right speaker.
➡Connect the speaker wires to the correct ones.
Left and right sounds
are reversed in stereo
listening.
Trouble Cause/Step
Trouble Cause/Step
Mounting angle is over 30o.
➡Adjust mounting angle to less than 30x.
Instable mounting.
➡Mount the unit securely with the mounting parts, referring to the
section on installation.
Sound skips due to vi-
bration.