Panasonic CS-S12NKUA, CS-S9NKUA, CU-S12NKUA, CU-S9NKUA manual Information

INFORMATION

FOR SEASONAL INSPECTION AFTER EXTENDED NON-USE

•Check remote control batteries.

•No obstruction at air inlet and air outlet vents.

•Use Auto OFF/ON button to select Cooling operation. After 15 minutes of operation, it is normal to have the following temperature difference between air inlet and air outlet vents:

Cooling: ≥ 14.4°F

FOR EXTENDED NON-USE

•Switch off power at the circuit breaker.

•Remove the remote control batteries.

NON SERVICEABLE CRITERIAS

SWITCH OFF POWER AT THE CIRCUIT BREAKER then please consult an authorized dealer under the following conditions:

•Abnormal noise during operation.

•Water/foreign particles have entered the remote control.

•Water leaks from Indoor unit.

•Circuit breaker switches off frequently.

•Switches or buttons are not functioning properly.

8

Information for Users on Collection and Disposal of Old Equipment and used Batteries

	[Information on Disposal in other Countries			Note for the battery symbol (bottom two
	outside the European Union]			symbol examples):
	These symbols are only valid in the European			This symbol might be used in combination with
	Union. If you wish to discard these items,			a chemical symbol. In this case it complies with
	please contact your local authorities or dealer			the requirement set by the Directive for the
	and ask for the correct method of disposal.		Pb	chemical involved.
Contact your local hazardous waste disposal hotline.
	Models Number	CS-S9NKUA / CU-S9NKUA
		CS-S12NKUA / CU-S12NKUA

The above listed models have been designed and manufactured to meet ENERGY STAR® criteria for energy efficiency when matched with appropriate coil components. However, proper refrigerant charge and proper air flow are critical to achieve rated capacity and efficiency. Installation of this product should follow the manufacturer’s refrigerant charging and airflow instructions. Failure to confirm proper charge and airflow may reduce energy efficiency and shorten equipment life.

Federal Communications Commission Interference Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and the receiver.

•Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, follow the attached installation instructions. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

Industry Canada Notice

This Class B digital apparatus complies with Canadian ICES-003.