ENGLISH |
INSTALLATION
Installation
Television Location
Follow these recommendations before deciding the location of your television.
•Avoid excessive sunlight or bright lights, including reflections.
•Keep away from excessive heat or moisture. Inadequate ventilation may cause internal component failure.
•Fluorescent lighting may reduce remote control transmitting range.
•Keep away from magnetic equipment, including motors, fans and external speakers.
WARNING: Use this television receiver only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from
avoid injury to children, never place your television receiver on a piece of furniture that is capable of being tilted by a child leaning on it, pulling on it, standing on it, or climbing on it. A falling television can cause serious injury or even death.
CAUTION: These television receivers for use only with PANASONIC
Optional Cable Connections
Shielded audio and video cables should be used between components. For best results:
•Use
•Use appropriate input and output connectors, that match your component connectors.
•Avoid long cables to minimize interference.
AC Power Supply Cord
CAUTION: TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO WIDE SLOT
OF AC OUTLET AND FULLY INSERT. DO NOT Polarized plug
USE A PLUG WITH A RECEPTACLE OR OTHER
OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT FROM THE APPARATUS.
Cable / Antenna Connection
For proper reception, either a cable or antenna connection is required.
Note: A cable converter box may be required for proper reception. Check with your local cable company for compatibility requirements.
Antenna Connections
• | For proper reception of VHF/ | Incoming Cable from | ||
| UHF | channels, | an external | Home Antenna |
| antenna is required. For best |
| ||
| reception an outdoor antenna |
| ||
| is recommended. |
| ||
Note: Cable Mode is preset at the |
| |||
factory. | Antenna | users must |
| |
change to TV Mode in the Set Up menu under Prog Chan.
Remote Control Battery Installation
Requires two AA batteries (supplied).
Battery Polarity
5A. |
|
1 / | AA |
| |
AA / 1. |
|
5A |
|
1 | 2 |
5A. |
|
1 | / |
| AA |
AA / 1. |
|
5A | |
3
Procedure
1.Turn the remote control face down. Remove battery cover by pressing down on the marking on the cover and sliding it off in the direction indicated.
2.Install batteries matching (+) and
3.Replace the battery cover by sliding in reverse until the lock snaps.
Note: Incorrect installation can cause battery leakage and
corrosion that will damage the Remote Control.
Precautions
•Replace batteries in pair.
•Do not mix battery types (zinc carbon with alkaline).
•Do not recharge, heat,
Cable Connection
Connect the cable supplied by your local cable company. Tighten with fingers only. Use of any tool (e.g. pliers) for tightening may result in tuner damage.
Incoming Cable from
Cable Company
75 Ohm VHF/UHF
on back of TV
4z
