HELPFUL INFORMATION

Auto Operation Button

ECONOMY POWERFUL

POWER QUIETI

TIMERI

Raise the front panel and press.

Automatic Operation

If the remote control fails to function or has been misplaced, press the Auto Operation button to start the Automatic operation.

The Automatic operation will be activated immediately once the Auto operation button is pressed. However, temperature cannot be adjusted when in this mode.

The power indicator on the indoor unit will blink until the operation mode is selected automatically.

To cancel this operation, press once more.

Remote Control Signal Receiving Sound

To switch off the beep (Signal Receiving Sound), press the Auto Operation button for 10 seconds continuously or longer.

A “beep”, “beep” sound will be heard at the tenth seconds.

Note : A “beep” sound will be heard at the fifth seconds;

However please press continuously until you heard “beep”, “beep” sound.

Repeat the above steps if you want to switch on the Signal Receiving Sound.

(This is for Servicing purposes only.)

Note: If you press this button continuously for 5 to 10 seconds, Test Run operation will be performed. A “beep” sound will be heard after five seconds indicating the Test Run starts to operate.

Auto Restart Control

If power is resumed after a power failure, the operation will restart automatically after 3 - 4 minutes.

Operation will be restarted automatically under the previous operation mode and airflow direction when power is resumed as the operation is not stopped by the remote control.

Timer Setting

When power failure occurs, the timer setting will be cancelled. Once power is resumed, reset the timer.

Thunder and Lightning

This air conditioner is equipped with a built-in surge protective device. However, in order to further protect your air conditioner from being damaged by abnormally strong lightning activity, you may switch off the circuit breaker.

ENERGY SAVING AND OPERATION HINTS

Setting the Temperature

Approximately 10% of electricity can be saved.

Set the temperature higher or lower than the desired temperature.

Cooling Model

Cooling Operation : 2°F higher

Heat Pump Model

Cooling Operation : 2°F higher

Heating Operation : 4°F lower

Air Filters

Clean the air filters every 2 weeks.

Dirty filters may reduces cooling or heating efficiency.

Keep All Doors and Windows Closed

Otherwise, cooling or heating performance will be reduced and electricity cost is wasted.

Outdoor Unit

Do not block the air outlet vents. Otherwise, it will lower the cooling or heating performance.

Timer

To prevent wastage of electricity, use Timer when going out.

Avoid Direct Sunlight

Keep curtains or drapes closed to avoid direct sunlight during cooling operation.

9