Panasonic DMCFX30K, DMC-FX30 operating instructions Troubleshooting, Please RE-CONNECT the Printer

Others

[PLEASE RE-CONNECT THE PRINTER.]

This message will be displayed if you change the mode dial to print mode [ ] while this unit and the PC are connected. If a printer is connected, change the mode to a mode other than [ ] mode and then check that no data is being transferred. ([ACCESS] appears on the LCD monitor of this unit while data is being transferred.)

[USB MODE CHANGED. PLEASE REMOVE THE USB CABLE.]

This message will be displayed if you change the mode dial to a mode other than print mode [ ] while this unit and the printer are connected.

Set the mode dial to [ ] again and then disconnect the USB cable. If printing, stop the printing and then disconnect the USB cable.

Troubleshooting

If you return the menu settings to the initial settings at the time of purchase, the condition may improve.

Select [RESET] in the [SETUP] menu. (P20)

∫Battery and power source

1:The camera cannot be operated even when it is turned on.

•Is the battery inserted correctly?

–Check the direction of the battery. (P12)

•Is the battery sufficiently charged?

–Use a battery that has been sufficiently charged.

2:The LCD monitor turns off while the camera is turned on.

•Is power save mode (P18) or economy mode (P18) activated?

–Press the shutter button halfway to cancel these modes.

•Is the battery exhausted?

–Use a battery that has been sufficiently charged.

3:The camera turns off immediately after it is turned on.

•Is the battery charge insufficient to operate the camera?

–Use a battery that has been sufficiently charged.

–If you leave the camera on, the battery will be exhausted. Turn the camera off frequently by using power save mode (P18) etc.

∫Recording

1:The picture cannot be recorded.

•Is the mode dial correctly set?

•Is there any memory remaining on the built-in memory or the card?

–Before recording, delete some pictures. (P29)

2:The recorded picture is whitish. The lens is dirty.

•The picture can become whitish if there is dirt e.g. fingerprints on the lens. If the lens is dirty, turn on the camera, eject the lens barrel (P9) and gently wipe the lens surface with a soft dry cloth.

3:The recorded picture is too bright or dark.

•Check that the exposure is correctly compensated. (P39)

4:2 or 3 pictures are taken at one time.

•Is auto bracket (P40) or burst mode set? (P64)

5:The subject is not focused properly.

•The focus range varies depending on the recording mode.

Rotate the mode dial to set the proper mode for the distance to the subject.

•Is the subject beyond the focus range of the camera? (P22, 42)

•Have you taken a picture with jitter?

99

VQT1B86