Panasonic DMCFS3S, DMCFS3K, DMCFS3A, DMC-FS3, DMC-FS5 About the Built-in Memory/the Card

Preparation

3 1: Close the card/battery door.

2: Slide the release lever in the direction of the arrow.

• If the card/battery door cannot be completely closed, remove the card, check its direction and then insert it again.

Note

•Remove the battery after use. Store the removed battery in the battery carrying case (supplied).

•Do not remove the battery until the LCD monitor and the status indicator (green) turn off as the settings on the camera may not be stored properly.

•The supplied battery is designed only for the camera. Do not use it with any other equipment.

•Before removing the card or battery, turn the camera off, and wait until the status indicator has gone off completely. (Otherwise, this unit may no longer operate normally and the card itself may be damaged or the recorded pictures may be lost.)

About the Built-in Memory/the Card

The following operations can be performed using this unit.

• When a card has not been inserted: Pictures can be recorded in the built-in memory and played back.

• When a card has been inserted: Pictures can be recorded on the card and played back.

• When using the built-in memory k>ð (access indication¢)

• When using the card

† (access indication¢)

¢ The access indication lights red when pictures are being recorded on the built-in memory (or the card).

Built-in Memory

•Memory size: Approx. 50 MB

•Recordable motion pictures: QVGA (320k240 pixels) only

•The built-in memory can be used as a temporary storage device when the card being used becomes full.

•You can copy the recorded pictures to a card. (P82)

•The access time for the built-in memory may be longer than the access time for a card.

Card

The following types of cards can be used with this unit. (These cards are indicated as card in the text.)

VQT1M97 15