Panasonic DMCFS3S, DMCFS3K, DMCFS3A Some Pictures Cannot be COPIED/COPY could not be Completed

Others

[SOME PICTURES CANNOT BE COPIED]/[COPY COULD NOT BE COMPLETED]

•The following pictures cannot be copied.

–When a picture with the same name as the picture to be copied exists in the copy destination. (Only when copying from a card to the built-in memory.)

–Files not based on the DCF standard.

•Moreover, pictures recorded or edited by other equipment may not be copied.

[BUILT-IN MEMORY ERROR FORMAT BUILT-IN MEMORY?]

•This message will be displayed when you formatted the built-in memory on a PC.

>Format the built-in memory on the camera again. (P25) The data on the built-in memory will be deleted.

[MEMORY CARD ERROR FORMAT THIS CARD?]

•This card has a format which is not recognized by the camera.

>Format the card again with the camera after saving necessary data on a PC etc. (P25)

[PLEASE TURN CAMERA OFF AND THEN ON AGAIN]

•This message appears when the camera is not operating properly.

>Turn the camera off and on. If the message persists, contact the dealer or your nearest Service Center.

[MEMORY CARD PARAMETER ERROR]

>Use a card compatible with this unit. (P15)

•You can only use an SDHC Memory Card if using cards with 4 GB or more capacity.

[MEMORY CARD ERROR PLEASE CHECK THE CARD]

•An error has occurred accessing the card.

>Insert the card again.

[READ ERROR

PLEASE CHECK THE CARD]

•An error has occurred reading the data.

>Insert the card again.

[WRITE ERROR

PLEASE CHECK THE CARD]

•An error has occurred writing the data.

>Turn the camera off and remove the card. Insert the card again and turn the camera on. Make sure the camera is turned off before removing or inserting the card to avoid damage.

[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE WRITING SPEED OF THE CARD]

•When you set the picture quality to [÷] or [û], we recommend using a high-speed card with “10MB/s” or greater displayed on the package.

•Depending on the type of SD Memory Card or SDHC Memory Card, motion picture recording may stop in the middle.

[A FOLDER CANNOT BE CREATED]

•A folder cannot be created because there are no remaining folder numbers that can be used. (P84)

>Format the card after saving necessary data on a PC etc. (P25) If you execute [NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100. (P23)

VQT1M97 95