Troubleshooting guide
Before requesting service, please perform the following steps.
∫Unit does not respond to remote control or unit’s buttons.
Disconnect AC power supply cord, wait 1 minute, then reconnect AC power supply cord.
Do you have the latest firmware installed? Panasonic is constantly improving the unit’s
firmware to ensure that our customers are enjoying the latest technology. (> 12)
4
Make the following checks and visit our website for more information.
For U.S.A. :
www.panasonic.com/support
Enter the model number.
For Canada :
http://www.panasonic.ca
4
Or visit our website to find a service center. You can find a service center near you easily
on our website.
Other support information:
“Customer Services Directory (United States and Puerto Rico)” (> 33) or “CONTACT INFORMATION” (> 34).
The following do not indicate a problem with this unit:
–Regular disc rotating sounds.
–Image disturbance during search.
∫Cannot eject disc.
1Turn the unit on.
2Press and hold [OK], the yellow button and the blue button on the remote control at the same time for more than 5 seconds.
–POWER LED starts to flash, and “00RET” is displayed on the screen.
3Press [1] (right) repeatedly on the remote
control until “06FTO” is displayed on the screen.
4Press [OK].
General operation
To return to the factory defaults.
¾Select “Yes” in “Restore Default Settings” in the Setup menu. (> 26)
To return all settings to the factory preset.
¾Reset the unit as follows:
1 Turn the unit on.
2 Press and hold [OK], the yellow button and the blue button on the remote control at the same time for more than 5 seconds.
–POWER LED starts to flash, and “00RET” is
displayed on the screen.
3Press [1] (right) repeatedly on the remote control until “08FIN” is displayed on the
screen.
4Press and hold [OK] for more than 5 seconds.
The remote control does not work properly.
¾Change the batteries in the remote control. (> 5)
¾The remote control and this unit are using different codes. Turn on this unit by using the standby/on switch on this unit, and check “Remote control ” which is displayed on the screen when you press a button on the remote control.
Press and hold [OK] and the displayed number (“”) for at least 5 seconds.
The TV tuner mode is not displayed when the TV is turned on.
¾This phenomenon may occur, depending on the TV setting, when “Quick Start” is set to “On”.
¾Depending on the TV, this phenomenon may be prevented by reconnecting the HDMI cable to a different HDMI input terminal or by changing the HDMI auto connection setting.
You have forgotten your ratings password. You want to cancel the ratings level.
¾The ratings level returns to the factory defaults.
1Turn the unit on.
2Press and hold [OK], the yellow button and the blue button on the remote control at the same time for more than 5 seconds.
– POWER LED starts to flash, and “00RET” is
displayed on the screen.
3Press [1] (right) repeatedly on the remote
control until “03 VL” is displayed on the screen.
4Press [OK].
Settings
Reference
SQT0108 27
