Panasonic DMP-BDT105 operating instructions Display, Dts/Dts-Hd

Audio

Dynamic Range Compression

You can listen at low volumes but still hear dialog clearly. (Dolby Digital, Dolby Digital Plus and Dolby TrueHD only)

≥“Auto” is effective only when playing Dolby TrueHD.

Digital Audio Output (> 36)

Press [OK] to show the following settings:

Dolby D/Dolby D +/Dolby TrueHD

DTS/DTS-HD

Select the audio signal to output.

≥Select “PCM”, when the connected equipment cannot decode the respective audio format.

≥Not making the proper settings may result in noise.

BD-Video Secondary Audio

Select whether to mix or not mix the primary audio and secondary audio (including the button click sound). (> 19)

≥If “Off” is selected, the unit outputs the primary audio only.

PCM Down Conversion

Select how to output audio with a sampling frequency of

96 kHz for the PCM output from the DIGITAL AUDIO OUT.

≥If “On” is selected, the signals that are converted to 48 kHz are output.

≥If “Off” is selected, and the connected equipment does not support 96 kHz, the sound will not be output normally.

≥Signals are converted to 48 kHz despite the settings in the following cases:

–when the signals have a sampling frequency of 192 kHz

–when the disc has copy protection

–when “BD-Video Secondary Audio” is set to “On”

Audio Delay

Mis-sync between the video and audio is corrected by delaying the audio output.

Display

Status Messages

Choose whether to show status messages automatically.

On-screen Language

Choose the language for menus and on-screen messages.

Screen Saver Function

This is to prevent burn-in on the screen.

≥When this is set to “On”:

If there is no operation for 10 minutes or more, Direct Navigator screen switches to FUNCTIONS screen automatically.

≥While playing and pausing, etc., this function is not available.

≥As for Music [CD-DA] or MP3, regardless of the setting, if there is no operation for a while, Direct Navigator screen switches to the other states automatically.

FL Display

Changes the brightness of the unit’s display.

≥If “Auto” is selected the display is dimmed during playback and bright not during playback.

License

Information about the software used by this unit is displayed.

Downmix

Select the downmix system of multi-channel to 2 channel sound.

≥Select “Surround encoded”, when the connected equipment supports the virtual surround function.

≥There is no effect on “Bitstream” via HDMI AV OUT and

DIGITAL AUDIO OUT.

≥The audio will be output in “Stereo” in the following cases;

–AVCHD playback

–Playback of secondary audio (including the button click sound).

7.1ch Audio Reformatting

Surround sound with 6.1ch or less is automatically expanded and played back at 7.1ch.

≥If “Off” is selected, sound is played over the original number of channels. (Note that in the case of 6.1ch audio, playback will be at 5.1ch.)

Audio reformatting is enabled in the following cases:

≥When you have selected “PCM” in “Digital Audio Output”.

≥When the audio is Dolby Digital, Dolby Digital Plus, Dolby TrueHD or LPCM.

Settings

VQT2U33 29