33
SQT0080
Reference
Cannot play.
¾You inserted an incompatible disc (Discs
recorded in PAL video, etc.).
Cannot display on this unit.
¾You tried to play a non-compatible image.
¾Re-insert the media.
No disc inserted.
¾The disc may be upside down.
$ This operation is not available.
¾Some operations are unsupported by the unit.
(For example, reverse slow motion, etc.)
IP address is not set.
¾The “IP Address” in “IP Address/DNS
Settings” is “---. ---. ---. ---”. Set the “IP
Address”, “Subnet Mask”, and “Default
Gateway”. (Select the automatic address
acquisition if necessary.)
The current wireless network security setting
is weak. It is recommended to change to a
stronger security setting.
¾Set a stronger network security level referring
to the wireless router owner’s manuals.
NET
¾While connecting to a network.
No PLAY
¾There is a viewing restriction on a BD-Video
or DVD-Video. (>27)
¾The media is dirty or badly scratched. The
unit cannot play.
REMOVE
¾The USB device is drawing too much power.
Remove the USB device.
SET (“ ” stands for a number.)
¾The remote control and this unit are using
different codes. Change the code on the
remote control.
Press and hold [OK] and the
indicated number button at
the same time for more than
5seconds.
U59
¾Temperature of this unit is hot and the unit
switches to standby for safety reasons.
Wait for about 30 minutes.
Install or place this unit with good ventilation.
H or F
(“” stands for a number.)
¾There is something unusual.
¾Check the unit using the troubleshooting
guide. If the service number remains
displayed, do the following.
1Disconnect the plug from the AC outlet, wait a
few seconds, then reconnect it.
2Press [Í/I] to turn the unit on.
If the service number remains displayed despite
doing the above, request service from the dealer.
Inform the dealer of the service number when
requesting service.
START
¾The system is being restarted during the
firmware update. Please do not turn off the
unit.
UPD/
(“” stands for a number.)
¾The firmware is being updated.
Please do not turn off the unit.
FIN
¾The firmware update is complete.
Messages on the screenMessages on the unit’s display
DMP-BDT460_360_SQT0080_eng.book 33 ページ ２０１３年１２月１９日　木曜日　午後３時０分