3 Attaching the control panel stand to the right or left side panel of the unit

(Diagram shows attachment to right armrest.)

1.Insert the attachment screw into the lower hole first

The position of the control panel when seated can be

and then tighten lightly by hand.

selected by choosing the appropriate hole for the screw.

 

2.Securing the stand with the attachment screws.

Near

Approx.

Tighten the two screws for the remaining two holes

 

20˚

lightly by hand and then tighten firmly with the allen key.

 

 

Far

 

 

Control panel stand

 

 

 

2

 

 

1 Insert the attachment

 

 

 

screw in either hole and

 

To attach the control panel stand using the attachment

then tighten.

 

Attachment screw

Allen key

screws, tighten the screws level with the holes as

shown in the figure below.

 

 

 

 

Use this screw

 

If the screws are tightened at an angle, the hole may

 

become deformed and the screws may become stuck in

Attachment Screw (M6 × 16)

 

 

the middle.

 

 

 

Control panel

 

 

 

× 3

 

Control panel stand

stand

 

 

 

Hole

Attachment screw

Attachment

 

Hole

screw

 

Allen key

Allen key

 

 

 

Tighten the screws

Do not tighten the

 

screw at an angle

 

level with the holes.

 

with the hole.

 

 

4 Attaching the control panel stand covers

(On both the right and left sides)

The method for attaching the covers is the same for both sides. The diagram shows the side where the control panel stand is attached.

Cover for Side WITH

Cover for Side WITHOUT

Control Panel Stand

Control Panel Stand

1.Insert the top tabs on the cover into the bottom notches on the armrest.

Notches

2.Insert the bottom tabs into the notches on the armrest.

Bottom tabs

 

Control panel

 

stand cover

Top tabs

Notches

Push the cover until you hear it click.

12

Page 13
Image 13
Panasonic EP30006 operating instructions Attaching the control panel stand covers