Parts identification
(see fig. 1)
AProtective cap
BSystem outer foil
CSystemouterfoilreleasebuttons
DFoil frame
EInner blades
FFoil frame release buttons
GOn/Off switch
HBattery capacity lamp
ICharge status lamp
JTrimmer
KTrimmer handle
LPower cord
MCleaning brush
NTravel pouch
Charging and cordless shaving
(see fig. 2)
When charging the shaver for the first time or when it has not been in use for more than 6 months, charge it for at least 8 hours before use.
Connect the power cord to the shaver and plug the power cord to an AC outlet.
It will adjust automatically to voltages between
In some areas, a special plug adaptor may be required.
The charge status lamp will glow when the shaver is being charged. It will flash when the charging is completed. You can fully charge the shaver in 1
hour if the battery capacity lamp blinks in red. The battery capacity lamp will glow in three colors depending on its charge capacity level:
100% - 30% : green
30% - 10% : orange
less than 10% : blinking in red
A full charge will supply enough power for approx. 14 shaves (3 minutes per shave for a normal beard).
Cord shaving
Connect the shaver to the AC outlet and turn the shaver on.
If the shaver does not run, charge it for approx. 1 minute.
Using your shaver
Push the On/Off switch to turn the shaver on. Hold the shaver at a right angle (90°) to your skin (see fig. 3). Start out shaving by applying gentle pressure to your face. Stretch your skin with your free hand and move the shaver back and forth in the direction of your beard. You may gently increase the amount of pressure as your skin becomes accustomed to this shaver. Applying excessive pressure does not provide a closer shave.
System outer foil (see fig. 4)
System outer foil has a slit blade (a) between 2 foils (b). They move up and down independently to follow the contours of your face.
The slit blade catches and cuts longer and lying hairs easily.
5