10 | e | d |
| ||
j |
| f |
| a | |
|
| |
| i | g |
|
| h |
b | c |
|
6
Parts identification
(see fig. 1)
AProtective cap
BSystem outer foil
CSystem outer foil release buttons
DFoil frame
EInner blades
FFoil frame release buttons
GOn/Off switch
ICharge (status) lamp
JTrimmer
KTrimmer handle
LPower cord
READ ALL INSTRUCTIONS BE- FORE USE.
Charging and cordless shaving
When charging the shaver for the first time or when it has not been in use for more than 6 months, charge it for at least 8 hours before use.
Connect the power cord to the shaver, and plug the power cord to an AC outlet.
It will adjust automatically to voltages between
In some areas, a special plug adap- tor may be required.
The charge (status) lamp will glow when the shaver is being charged. It will flash when the charging is com- pleted.
7
7
A full charge will supply enough power for approx. 14 shaves (3 min- utes per shave for a normal beard).
(For ES8017/ES8018/ES8019, see fig. 2)
You should charge the shaver for 1 hour if the battery capacity lamp blinks red.The battery capacity lamp will glow in three colors depending on its charge capacity level:
100% - 30% | : green |
30% - 10% | : orange |
less than 10% | : blinking in red |
(For ES8016, see fig. 3)
You should charge the shaver for 1 hour if the low battery indicator glows.
Cord shaving
Connect the shaver to the AC outlet and turn the shaver on.
If the shaver does not run, charge it for approx. 1 minute.
Using your shaver
Caution – The system outer foil is very thin and can be damaged if handled improperly. Before each use, always check the foil for dam- age. To avoid personal injury, do not use if the foil or other parts of the shaving head is damaged.
Push the On/Off switch to turn the shaver on. Hold the shaver at a right angle (90°) to your skin (see fig. 4). Start out shaving by applying gentle pressure to your face. Stretch your skin with your free hand and move the shaver back and forth in the di-
