[POSITION]menu menu
Select [POSITION] from the main menu, and select the item from the
Refer to “Navigating through the menu”
( page 27) for the operation of the menu screen.
[SHIFT]
You can move the image position vertically or horizontally if the image position projected on the screen is shifted even when the relative position of the projector and the screen is installed correctly.
1)Press ▲▼ to select [SHIFT].
2)Press the <ENTER> button.
zzThe [SHIFT] individual adjustment screen is displayed.
3) Press ▲▼◀▶ to adjust the position.
■■For vertical (up and down) adjustment
OperationAdjustment
The picture
Press ▲ . position moves up.
The picture
Press ▼ . position moves down.
■■For horizontal (right and left) adjustment
OperationAdjustment
The picture
Press ▶ . position moves to the right.
The picture
Press ◀ . position moves to the left.
[CLOCK PHASE]
You can adjust to achieve an optimal image when there is a flickering image or smeared outlines.
1)Press ▲▼ to select [CLOCK PHASE].
2)Press ◀▶ or the <ENTER> button.
zzThe [CLOCK PHASE] individual adjustment screen is displayed.
3) Press ◀▶ to adjust.
zzAdjustment value will change between 0 and +31. Adjust so that the amount of interference is at a minimum.
Note
zzOptimal value may not be achieved if the output from the input computer is unstable.
zzWhen dot clock frequency of projecting signals is 162 MHz or higher, noise may not be eliminated even if [CLOCK PHASE] is adjusted.
zzAdjustment is disabled when the component (YCBCR) signal of 525i (480i), or 625i (576i) is input.
zzAdjustment is disabled while the computer (RGB) signal of 525i (480i), or 625i (576i) is input.
zzAdjustment is disabled when a digital signal is input.
[OVER SCAN]
zzSupported only when
YCBCR/YPBPR/RGB (movie)/DVI (movie)/ HDMI (movie) signal is input
Adjusts the screen when characters or images at four edges of the screen are not completely displayed.
1)Press ▲▼ to select [OVER SCAN].
2)Press ◀▶ or the <ENTER> button.
zzThe [OVER SCAN] individual adjustment screen is displayed.
3) Press ◀▶ to adjust.
zzAdjustment value is from 0 to +10.
32 - ENGLISH