Cutting depth adjustment
•Remove battery pack.
•Loosen the depth adjustment lever by pushing it and adjust the cutting depth.(See Fig.5)
Tighten the depth adjustment lever securely by lifting it up towards the motor housing at the desired cutting depth.
Rip fence (EY3500B7727)
(Available as an optional accessory, not included) Rip fence is convenient for rip cuts and repeated cuts of same width.
•Remove battery pack.
•Insert rip fence and adjust cutting width. (See fig. 8) •Fasten screw securely to fix rip fence.
When material is 10mm (3/8") or less thick, adjust the cutting depth so that the blade protrudes approx. 5mm (3/16") from the bottom of material
Tighten |
|
|
1 |
| 2 |
|
| Fasten knob |
2 |
| 1Insert and adjust |
|
| |
Loosen | Depth adjustment lever |
|
| Rip Fence | |
|
|
Fig. 5 |
| |
Fig. 8 | ||
Bevel cutting adjustment | ||
|
•Remove battery pack.
•To adjust the bevel of cut setting, loose the bevel adjusting knob. Turn the bevel adjusting knob counterclockwise.(See Fig.6) Adjust the bevel of cut.
To set the bevel of cut at 90 degree, use a trian- gle. To have fine bevel adjustment, use the bevel adjustment screw on the base. (See Fig.7)
•Tighten the bevel adjusting knob securely.
Tighten |
Loosen |
Fig. 6
Bevel adjustment screw
Fig. 7
- 11 -
