WARNING:
Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
*Lead from
*Crystalline silica from bricks and cement and other masonry products
*Arsenic and chromium from chemically- treated lumber.
To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
For Battery Charger & Battery Pack
Important Safety Instructions
1)SAVE THESE INSTRUCTIONS-
This manual contains important safety and operating instructions for battery charger EY0110.
2)Before using battery charger, read all instructions and cautionary markings on battery charger, battery pack, and product using battery pack.
3)
Other types of batteries may burst causing personal injury and damage.
4)Do not expose charger and battery pack to rain or snow.
5)To reduce risk of damaging the electric plug and cord, pull by plug rather than cord when disconnecting charger.
6)Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
7)An extension cord should not be used unless absolutely necessary.
Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure:
a.that pins on plug of extension cord are the same number, size and shape as those of plug on charger.
b.that extension cord is properly wired and
in good electrical condition.
c.that wire size is large enough for ampere rating of charger as specified below.
RECOMMENDED MINIMUM AWG SIZE OF
EXTENSION CORDS FOR
BATTERY CHARGERS
AC Input Rating. | Amperes | AWG Size of Cord | |||
Equal to or | But less | Length of Cord, Feet | |||
greater than | than | 25 | 50 | 100 150 | |
0 | 2 | 18 | 18 | 18 | 16 |
8)Do not operate charger with damaged cord or plug — replace them immediately.
9)Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified service personnel.
10)Do not disassemble charger; take it to a qualified service personnel when service or repair is required. Incorrect reassem- bly may result in a risk of electric shock or fire.
11)To reduce the risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning.
12)The charger and battery pack are specifi- cally designed to work together.
Do not attempt to charge any other cord- less tool or battery pack with this charger.
13)Do not attempt to charge the battery pack with any other charger.
14)Do not attempt to disassemble the battery pack housing.
15)Do not store the tool and battery pack in locations where the temperature may reach or exceed 50°C (122°F) (such as a metal tool shed, or a car in the summer), which can lead to deterioration of the stor- age battery.
16)Do not charge battery pack when the tem- perature is BELOW 0°C (32°F) or ABOVE 40°C (104°F). This is very important in order to maintain optimal condition of the battery pack.
17)Do not incinerate the battery pack. It can explode in a fire.
18)Avoid dangerous environment. Do not use charger in damp or wet locations.
19)The charger is designed to operate on standard household electrical power only. Do not attempt to use it on any other volt- age!
20)Do not abuse cord. Never carry charger by cord or yank it to disconnect from outlet. Keep cord away from heat, oil and sharp edges.
- 7 -
