Read “Safety Instructions” booklet and the following before using.
.ADDITIONAL SAFETY
RULES
1)Wear ear protection. Exposure to noise can cause hearing loss.
2)Be aware that this tool is always in an operating condition, since it does not have to be plugged into an electrical outlet.
3)When drilling into walls, floors, etc., “live” electrical wires may be encountered. DO NOT TOUCH THE CHUCK OR ANY FRONT METAL PARTS OF THE TOOL! Hold the tool only by the plastic handle to prevent electric shock in case you drill into a “live” wire.
4)If the bit becomes jammed, immediately turn the trigger switch off to prevent an overload which can damage the battery pack or motor. Use reverse motion to loosen jammed bits.
5)Do NOT operate the Forward/Reverse lever when the trigger switch is on. The battery will discharge rapidly and damage to the unit may occur.
6)When storing or carrying the tool, set the Forward/Reverse lever to the center position (switch lock).
7)Do not strain the tool by holding the speed control trigger halfway (speed control mode) so that the motor stops. The protection circuit will activate and may prevent speed control operation. If this happens, release the speed control trigger and squeeze again for normal operation.
8)Be careful not to get dust inside the chuck.
9)Do not touch the rotating parts to avoid injury.
10)Do not use the tool continuously for a long period of time. Stop using the tool from time to time to avoid temperature rise and heat overload of the motor.
11)Do not drop the tool.
Symbol | meaning |
VVolts
Direct current
n0 | No load speed | ||
|
|
|
|
…/min | Revolutions or | ||
reciprocations per minutes | |||
|
|
| Rotation with hammering |
|
|
| |
|
|
|
|
|
|
| Rotation only |
- -
EY6803(EU).indb 4
2006/04/10 | 9:41:27 |
|
|
|
|
|
| ||
|
|
| ||
|
|
|
|
|
