NOTE: Use under extremely hot or cold conditions will reduce operating capacity per charge.

Battery Recycling

For environmental protection and recycling of materials, be sure that it is disposed of at an officially assigned location, if there is one in your country.

Battery Charger

NOTE: Charge a new battery pack, or a battery pack that has not been used for a prolonged time, for about 24 hours to bring the battery up to full charge.

Battery charger (EY0110)

1. Plug the charger into the AC outlet.

NOTE: Sparks may be produced when the plug is inserted into the AC power supply, but this is not a problem in terms of safety.

2.Insert the battery pack firmly into the charger.

Battery pack

To AC outlet

Battery charger

3.During charging, the charging lamp will be lit.

When charging is completed, an internal electronic switch will automatically be triggered to prevent overcharging.

Charging will not start if the battery pack is warm (for example, immediately after heavy-duty operation).

The orange standby lamp will be lit until the battery cools down. Charging will then begin automatically.

4.When charging is completed, the charging lamp will start flashing quickly in green color.

5.When in any of the conditions that battery pack is too cool, or the battery pack has not been used for a long time, the charging lamp is lit. In this case charging takes longer to fully charge the battery pack, than the standard charging time.

If a fully charged battery pack is inserted into the charger again, the charging lamp lights up. After several minutes, the charging lamp may flash quickly to indicate the charging is completed.

6.If the charging lamp does not light immediately after the charger is plugged in, or if after the standard charging time the lamp does not go off, consult an authorized dealer.

NOTE: • When charging a cool battery pack (below 5°C (41°F)) in a warm place, leave the battery pack at the place and wait for more than one hour to warm up the battery to the level of the ambient temperature. Otherwise battery pack may not be fully charged.

Cool down the charger when charging more than two battery packs consecutively.

Do not insert your fingers into contact hole, when holding charger or any other occasions.

CAUTION:

To prevent the risk of fire or damage to the battery charger.

Do not use power source from an engine generator.

Do not cover vent holes on the charger and the battery pack.

Unplug the charger when not in use.

- -

EY6803(EU).indb 7

2006/04/10

9:41:32

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 7
Image 7
Panasonic EY6803 operating instructions Battery Recycling, Battery Charger, Battery charger EY0110