. ACCESSORIES
CAUTION:
To prevent the risk of injury, only use accessory or attachment for its stated purpose.
Bit adapter •EY9HX403
Drill chuck (Optional accessory) •EY9HX400
Hammer chuck (Optional accessory) •EY9HX401
Battery pack •EY9201
Battery charger •EY0110
If you need any assistance for more details regarding these accessories, ask your local service center.
. USAGE
SUGGESTION
1.If there isn’t enough force pushing down on the bit, the hammer may not be able to blow in hammering mode.
This is to prevent the hammering mode from operating with no load. Press down harder on the bit to engage the hammer and cause it to blow.
Always be sure to press down with enough force when working.
2.In winter or in other situations where the temperature of the unit is low (5°C or below), the blow of the hammering mode may be weaker than normal at the beginning stage.
This is because the grease becomes stiffer in low temperatures, increasing friction. If this should happen, operating hammering mode with no load for approximately 30 seconds and repeat this 3 times. This will restore its blowing power.
.SPECIFICATIONS
MAIN UNIT (EY6803)
Maximum drilling | Concrete | 10 mm (25/64") *12.5 mm (15/32") | |
*For work that can be completed with one battery pack. | |||
diameter |
| ||
|
| ||
Steel | 13 mm (33/64") | ||
| |||
Motor voltage |
| 12 V DC | |
|
| ||
Speed at no load (RPM) | |||
|
| ||
Blows rate per minute (BPM) | |||
|
| ||
Weight (with battery pack) | 2.5 kg (5.5 lbs) | ||
|
| ||
Dimensions (L×W×H) | 249×257×64 mm | ||
|
|
| |
- -
EY6803(EU).indb 9
2006/04/10 | 9:41:34 |
|
|
|
|
|
| ||
|
|
| ||
|
|
|
|
|
