-
6
-
summer), which can lead to deterioration
of the storage battery.
16) Do not charge battery pack when the
temperature is BELOW 0°C (32°F) or
ABOVE 40°C (104°F). This is very impor-
tant in order to maintain optimal condition
of the battery pack.
17) Do not incinerate the battery pack. It
can explode in a fire.
18) Avoid dangerous environment. Do not
use charger in damp or wet locations.
19) The charger i s designed to operate on
standard household electrical power
only. Do not attempt to use i t on any
other voltage!
20) Do not abuse cord. Never carry charger
by cor d or yank it to disconn ect fr om
outlet. Keep c ord aw ay from heat, oil
and sharp edges.
21) Charge the battery pack in a well ven-
tilated place, do not cover the charger
and battery pack with a cloth, etc., while
charging.
22) Use of an attachment not recommend-
ed may result in a risk of fire, electric
shock, or personal injury.
23) Do not short the battery pack. A battery
short can ca use a large curre nt flo w,
over heating and create the risk of fire
or personal injury.
24) NOTE: If t he s upply cord of this ap-
pliance is damaged, it must only be re-
placed by a repair shop authorized by
the manufacturer, because special pur-
pose tools are required.
25)
TO REDUCE THE RISK OF ELECTRIC
SHOC K, THI S A PPLI ANC E HAS A
POLARIZED PLUG (ONE BLADE IS
WIDER THAN THE OTHER).
This plug will fit in a polarized outlet
only one way. If the plug does not fit
fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
IV
. ASSEMBLY &
OPERATIONHexagonal Bit Chuck
Attaching the bits
NOTE:
When a ttaching or removing drill
bits, disconnect the battery pack
from the tool and switch the lock
button into the lock position.
1. Hold the collar of the chuck and pull it
out from the driver.
2. Insert the bit into the chuck. Release
the collar.
3. The collar will retu rn to its origin al
position when it is released.
4. Pull the bit to make sure it does not
come out.
5. To remove the bit, pull out the collar
in the same way.
Bit Hexagonal bit chuck
9.5 mm (3/8") - 13 mm (33/64") 6.35 mm (1/4")
Clutch Handle
(Clutch Torque Setting)
Adjust the torque to one of the 21 pos-
sible settings to the job. There is an
interval of about 0.13 N·m (1.3 k f-cm
or 1.1 in-lbs) between steps.
CAUTION:
Test the setting before actual opera-
tion.
Set the scale at this mark.
EY7410(UL).indb 6 2006/09/08 17:30:50