Panasonic EY7410 operating instructions  Battery Low Warning Lamp,  Using the LED Light

Reference for Adjusting Torque

Setting Torque Use

1Approx: 0.29 N·m

(3.0 kgf-cm or 2.6 in-lbs)

5Approx: 0.82 N·m

(8.4 kgf-cm or 7.3 in-lbs)

9	Approx: 1.35 N·m
	(13.8 kgf-cm or 12.0 in-lbs) For driving
		screws
13	Approx: 1.88 N·m
	(19.2 kgf-cm or 16.6 in-lbs)

17Approx: 2.41 N·m

(24.6 kgf-cm or 21.3 in-lbs)

21Approx: 2.94 N·m

(30.0 kgf-cm or 26.0 in-lbs)

For power-

Approx: 4.4 N·m ful driving (45.0 kgf-cm or 39.0 in-lbs) screws and

drilling

●When using at high speeds, set the clutch at 10 or below. (Operation stops at the maximum torque of 1.5 N·m (15 kgf-cm) when the scale is higher.)

●The auto shut-off function may be­ come inoperable at higher clutch settings when battery power drops. Recharge the battery in that case.

NOTE:

The chart is only a reference. The torque settings may differ by materi- als, types of screws, etc. Please test it at your own conditions before use.

Battery Low Warning Lamp

<Battery low warning lamp>

Off	Flashing
(normal	(No charge)
operation)	Battery
	protection
	feature active

Excessive (complete) discharging of Li-ion batteries shortens their service life dramatically. The driver includes a battery protection feature designed to prevent excessive discharging of the battery pack.

●The battery protection feature acti- vates immediately before the bat-

tery loses its charge, causing the battery low warning lamp to flash.

●If you notice the battery low warn- ing lamp flashing, charge the bat- tery pack immediately.

Using the LED Light

Use the LED light on jobs in dark locations such as attics to illuminate your workspace.

CAUTION

●The LED light is intended for use as a supplemental light source. Do not use it as a flashlight.

Doing so may result in accident or injury.

●Do not look at the light or shine it directly into your eyes. Continuous exposure to the LED light may damage your eyes.

1.Press to toggle the light on and off.

●To use the light immediately after attaching the battery pack or after the drill has not been used for 5 minutes or more, operate the drill briefly.

●The light will automatically turn off if the drill is not used for 5 minutes.

●The light uses an extremely small amount of current. Using the light

- -