has a negligible effect on the operational capacity of the drill.
●The LED is incapable of lighting the tip of the bit when the drill is used in the straight configuration.
Bit-locking Function
With the switch at off and the bit lock ed in place, the tool can be used as a manual
There will be a little play in the driving shaft, but this is not a malfunction.
Main Switch (ON/OFF)
Push the upper half of the switch for forward rotation, or the lower half for reverse rotation.
Forward
Forward 
Reverse
Reverse
| Speed selection | Torque | |
LOW |
| 200 /min (rpm) | High |
HIGH |
| 600 /min (rpm) | Low |
CAUTION:
•Check speed selector switch before use.
•Do not operate the speed selector switch while the main switch is on (switch is in the ON position).
Main Switch Lock
After use, set the main switch lock at the lock position to prevent accidental operation.
Main switch lock | Lock |
|
Battery Pack (EY9L10)
CAUTION:
1.Remove the battery pack away from the tool.
2.Charge the battery pack using the battery charger.
3.After charging has been completed, remove the battery pack from the charger and connect it to the tool.
Disconnect the charger from the power source when not in use.
Speed Selector Switch
To suit the application of this tool, two different rotational speeds are avail- able. Depending upon use, either the high or low speed should be select- ed.
HIGHLOW
NOTE:
Use under extremely hot or cold conditions will reduce operating capacity per charge.
- -
