-
9
-
• When the belt hook is not used, be
sure to return it to the storing posi-
tion. The belt hook may catch on
something.
This may result in an accident or
injury.
•
When the unit is hooked onto the
waist belt by the belt hook, do not
attach driver bits to the unit. A sharp
edge objec t, such as a drill bit, may
cause injury or an accident.
To Set the Belt Hook Angle Position
1. Slide the belt hook lock lever 1 and
hold it to unlock the belt hook.
21
3
2. Pull th e b el t h oo k
from storing position
2 and set it.
3.
Release the belt hook
lock lever to
lock the
angle of belt hook.
4.
Make sure th e be lt h ook is firml y
locked. Also make sure the belt hook
is firmly locked into position
3
.
• The belt hoo k c an-
not be locked in this
position. Firmly lock
it into position before
use.
To return the belt hook to the storing
position, follow step 1. and 2. abo ve,
then lower the belt hook.
To se cure the loc k, foll ow 3 an d 4
above.
To Change the Belt Hook Location Side
The belt hook ca n be att ached to
either side of the unit.
1. Set the bel t hook at s toring posi-
tion.
2. Loosen the screw turning it coun-
ter-clockwise, using a flat metal or
a flat blade screw driver.
3. Take out the belt hook and insert
into the other side of the slot on the
main unit.
4. Fasten the screw firmly, turning it
clockwise.
The belt hook can be taken out from
the main unit only when it is at storing
position.
Control Panel
(1) (2)
(3)
(1) LED light
Pressing toggles the
LED light on and off.
The light illuminates with
very low current, and it
does not adversely affect
the performance of the
driver during use or its bat-
tery capacity.
CAUTION:
• The built-in LED light is designed to
illuminate the small work area tem-
porarily.
•
Do not use i t as a substi tute for a
regular
flashlight, since it does not
have enough brightness
.
This product has the built-in LED light.
This product is classified into
“
Class 1
LED Product
”
to EN 60825-1
Class 1 LED Product
Caution : DO NOT STARE INTO BEAM.
(2) Overheat warning lamp
Off
(normal
operation)
Flashing: Overheat
Indicates operation has
been halted due to battery
overheating.
The overheating protection feature
halts driver operation to protect the
battery pack in the event of over-
heating. The overheat warning lamp
EY7440(UL).indb 9 2006/09/13 9:39:49