7)Do not strain the tool by holding the speed control trigger halfway (speed control mode) so that the motor stops.
Symbol | Meaning | ||||||
|
| V | Volts | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Direct current |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| n0 | No load speed | ||||
|
|
|
|
|
|
|
|
… | Revolutions or reciprocations | ||||||
|
|
|
|
|
|
| per minutes |
| Ah | Electrical capacity of battery | |||||
| pack | ||||||
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
IV. ASSEMBLY
Attaching or Removing Bit
NOTE:
•When attaching or removing a bit, discon- nect battery pack from tool or place the switch in the center position (switch lock).
1.Hold the collar of quick connect chuck and pull it out from the tool.
2.Insert the bit into the chuck. Release the collar.
3.The collar will return to its original position when it is released.
4.Pull the bit to make sure it does not come out.
5.To remove the bit, pull out the collar in the same way.
CAUTION:
•If the collar does not return to its origi- nal position or the bit comes out when pulled on, the bit has not been properly attached. Make sure the bit is properly attached before use.
EYFLA4A/EYFLA4AR/EYFLA5A/EYFLA5AR
12 mm | 9 mm – 9.5 mm | 6.35 mm |
(15/32") | (23/64" – 3/8") | (1/4") |
Attaching Socket (Pin type)
•Remove the socket’s rubber ring and pin.
rubber ring 
groove
pin
1 Attach the socket to the tool.
2 Insert the pin. (Taking care to align the pin holes on the socket and tool.)
3 Attach the rubber ring by sliding it into place over the groove.
NOTE:
Be sure to attach the rubber ring to prevent the pin from falling out.
Removing Socket (Pin type)
1 Remove the rubber ring.
2 Remove the pin.
3Remove the socket from the tool.
NOTE:
Keep the temperature of the tool above the freezing point (0°C/32°F) when attach ing sockets to or detaching them from the square drive on the tool. Do not use excessive force when attaching or detach ing sockets.
- -
