FAN SPEED TO SELECT FAN SPEED (3 OPTIONS)
AUTO LOW MEDIUM HIGH
•For AUTO, the indoor fan speed is automatically adjusted according to the operation mode.
•If the operation mode is set to Fan, the fan speed will be fixed at MEDIUM regardless of the temperature setting.
AIR SWING | TO ADJUST AIRFLOW |
| |
AUTO MANUAL DIRECTION |
•Keeps the room ventilated.
•The air is discharge evenly through 4 output vents.
AUTO 1 |
|
|
| AUTO 2 |
|
|
| AUTO 3 |
AUTO
•There are 3 options for auto vertical airflow direction.
•The vertical airflow louver swings up and down automatically.
•Do not adjust the vertical airflow direction louvers by hand.
MANUAL
•There are 4 options for manual vertical airflow direction.
•The airflow direction can be adjusted as desired by using remote control.
ECONOMY | TO REDUCE POWER | ECONOMY |
| CONSUMPTION |
|
•Recommend to use when desired room temperature is reached.
•Economy operation can be activated in all modes and can be cancelled by pressing the respective button again.
ODOUR WASH | ODOUR WASH |
ODOUR REMOVING
•Applicable for all models.
•Helps to remove unpleasant odour from the surrounding area during operation.
•To enable the odour removing function, press the
ODOURWASH once.
• To cancel, press the respective button again.
ODOUR CLEAR
•Applicable for Inverter model only.
•To remove odour and minimize the growth of odour causing moulds in the air conditioner’s interior section.
•To enable this function, press the ODOUR WASH for more than 3 seconds.
•The unit will automatically perform Fan and Heating modes for approximately 20 minutes and then stops automatically.
•Recommended to open the windows during this operation.
TO SET DAILY TIMER
• To turn ON or OFF the unit at a preset time.
|
| TIMER |
SELECT |
|
|
|
| SET |
Select ON or | Set the time. | Confirm. |
OFF timer. |
|
|
•To cancel ON or OFF timer, press CANCEL .
•When ON timer is set, the unit may start early before the actual set time in order to achieve the desired temperature on time.
•Timer operation is based on the clock set in the remote control and repeats daily once set. For clock setting, please refer to Remote Control preparation.
•The timer closest to the current time will be activated first.
•If timer is cancelled manually, you can restore the previous setting by pressing SET .
•If the main power is switched off for an hour or more, the clock and timer will need to be set again.
OPTIONAL SETTINGS
•To avoid unintentional operation, you can assign a different address to each indoor unit.
•Press repeatedly to select your desired address setting.
Group Address 1 Address 2 Address 3
ADDRESS | • By default, ADDRESS 1 is selected. You |
| |
| do not need to change this setting for |
| normal operation. |
| • If the address is set to GROUP, more |
| than one indoor unit can be operated at |
| the same time. |
| Press to restore the remote control’s default |
RESET | setting. |
| |
|
|
SET | Not used in normal operations. |
HINTS
•Set the temperature 1°C higher in cool mode or 2°C lower in heat mode than the desired temperature to achieve a 10% power saving.
•Use curtains to screen off sunlight and outdoor heat to reduce power consumption during cool mode.
ENGLISH
5