Panasonic GCSEB E HT870, Front and surround speaker assembly, Attach the pipe to the base

Simple setup		Make sure you have all the indicated components before starting the assembly, setup, and
STEP1		connection.	2 front and	4 large washer 4 mounting plates
		4 bases
	[HT870]		4 pipes 2 surround	screws
			speaker units

8 small screws

Front and surround speaker assembly

[Note]

The front and surround speaker pairs as well as the pipe pairs are different.

–Check the label on the rear of the speaker before attaching the pipe (‹ page 8).

–The pipe with the shorter cable is for the front speaker unit.

Preparation

≥To prevent damage or scratches, lay a soft cloth and perform assembly on it.

≥For assembly, use a Phillips-head screwdriver.

1 Attach the pipe to the base.

2Attach the plate A to the speaker.

Ensure the plate A is fastened on straight by lightly tightening the top and bottom screws alternately until fully tightened.

Small screws

Speaker

Plate A

Polyfoam

1Thread the speaker cable through the base.

Lessen excess speaker cable.

	Thread the
Cable	speaker cable
	through here.
	Hole for screw

Groove

2Insert the pipe.

You can also attach to the upper rear of the speaker.

The height of the speaker is indicated in the diagram

(‹ page 5) when attaching the plate A to the upper rear or lower rear of the speaker.

3Place the pipe on the plate A and attach the plate B.

Plate B	Rotate the pipe so that the flat
	side is facing away from the
	back of the speaker.

Front and surround speaker assembly

Insert the pipe while slightly pulling on the speaker cable.

3Secure the pipe to the base.

Ensure the screw is securely fastened.

Rear side of base

Large washer screw

Fit the offset into the slot and slide the plate B into the locked position.

Plate B

Cable

The supplied stands are specially designed for attachment to Panasonic SB-PF921 front speakers and SB-PS921 surround speakers. Only use as indicated in this setup.

2 Attach the stand to the front and surround speaker.

≥There is no difference between the right and left speakers and stands. ≥Using the polyfoam included with this unit may be convenient.

1 Remove the screw and separate the mounting plate into two parts.

Plate B Plate A

Offset

Slot

4Secure the plate with the same screw removed in procedure 1.

Small screw

RQT7429

4

Small screw