6
VQT4Y54
6[O.I.S.] switch
When the lens is attached to the camera the
stabiliser function is set to activate if the [O.I.S.]
switch is set to [ON].
≥We recommend setting the [O.I.S.] switch to [OFF]
when using a tripod.
≥The stabiliser function may not be effective in the
following cases.
–When there is a lot of jitter.
–When the zoom magnification is high.
–When using the digital zoom.
–When taking pictures while following a moving
subject.
–When the shutter speed becomes slower to take
pictures indoors or in dark places.
Note
≥When flash recording with a close subject, the
light of the flash will be blocked by the lens and
part of the picture may be dark. Check the
distance from the subject when recording.
≥
If you zoom after focusing, focusing errors may occur.
After zooming, please perform the focusing again.
Attaching/Detaching the Lens≥Refer also to the camera’s
operating instructions for
attaching and detaching the lens.
≥Check that the camera is turned
off.
≥Remove the lens rear cap from the lens.
∫Attaching the Lens
Align the lens fitting
marks A on the
camera body and the
lens and then rotate
the lens in the
direction of the arrow
until it clicks.
•Do not press the lens release button B when
you attach a lens.
•Do not try to attach the lens when holding it at an
angle to the camera body as the lens mount may
get scratched.
•Check that the lens is attached correctly.
•Be sure to remove the lens cap when recording.
VQT4Y54_E.book 6 ページ ２０１３年４月１２日 金曜日 午後２時２分