39
VQT3U98
Convergence point adjustment
∫About the convergence point
Convergence point is a position that becomes the reference plane of the 3D image.
When viewing the 3D image, a subject located closer than the convergence point is
displayed in front of the screen, and a subject located farther than the convergence point is
displayed behind the screen.
∫Adjusting the convergence point
It is recommended to prepare for recording, such as adjust the convergence point in
accordance with the position of the subject in advance, determine the construction of the
image to record, etc., to record an image that is effective as 3D vid eo. It is also
recommended to adjust the convergence point again when the distance between this unit
and the subject is changed significantly.
1Display the convergence.
To ensure that the 3D image can be safely viewed , pay attention to the following
points when adjusting the convergence point.
≥The image may cause tiredness or discomfort when adjustment of the convergence point
is frequently performed, or the position of the subject is further away in front or rear of the
convergence point or at the edge of the image.
≥Stop the operation when you feel fatigue, discomfort, or otherwise strange while
adjusting.
: [SW & DISP SETUP] # [CONVERGENCE] # [ON]
AConvergence point
BDisplay in front of the screen
CDisplay behind the screen
* The image is an illustration.
MENU
HDC-Z10000P-VQT3U98_mst.book 39 ページ ２０１１年１０月４日 火曜日 午後３時２分