Setup
Registering the camera
This procedure is not required for devices that were included as part of a bundle.
Before you can use the camera, it must be registered to the hub.
If the camera is not registered to a hub, the camera’s LED indicator blinks in amber. You can register each device by using the registration buttons or the [Home Network] app.
Note:
RBefore registering the camera, make sure the AC adaptors of the hub and camera are connected and each device is powered.
Using registration buttons
1Hub:
Press and hold M
CAMERAN until the LED indicator blinks in green.
2Camera:
Using an object with a thin tip, press and
hold M
N until the LED indicator blinks in green (page 15).
R When registration is complete, the hub sounds one long beep.
Note:
RTo cancel the registration, press the registration button on the hub and on the camera.
RIf registration fails, the hub sounds several short beeps.
Using the app
When you register the camera by using the [Home Network] app, you can assign a name to your devices and group them by location. For more information, refer to the User’s Guide (page 26).
Confirming the registration area
Before deciding where to install the camera, carefully read the chapter “Installation Location”, beginning on page 8, to confirm the installation location and direction.
16For assistance, please visit www.panasonic.com/support
