Setup
Part names and functions
G 
H
Indicator
Red, blinking
Red, blinking quickly
Amber, blinking
Status
Live images are being viewed or recorded
Camera is out of range of the hub, or device malfunction
Camera is not registered to a hub
I
J
A B C D E F
Microphone
Sensor range cap (Standard)
Infrared sensor
LED indicator
Lens unit
Speaker
M
N
Used when registering the camera to the hub.
Safety wire
Camera mounting stand
DC cable
LED indicator
You can use the LED indicator to confirm the camera’s status.
*1 You can configure the camera so that its LED indicator does not light during normal operation. For more information, refer to the User’s Guide (page 26).
Setup overview
1Initial setup
Make sure you can access the system using your mobile device. For details, refer to the System Setup Guide included with your hub.
2Registration
Required only if the camera was purchased separately (i.e., not as part of a bundle).
3Confirm the installation area
Read the information in this document to confirm that the desired installation area is suitable to proper operation.
4Installation
Install the camera in the desired location and connect the camera to the power outlet.
5 Adjust the infrared sensor range |
Confirm the sensor range area and adjust |
Indicator
Off
Green, lit
Green, blinking
Red
Status
No power, or LED indicator is turned off*1
Normal operation*1
Registration mode
Motion detection features were triggered
it if necessary using the included sensor |
range adjustment caps. |
For assistance, please visit www.panasonic.com/support | 15 |
