For your safetyLaser radiation
CLASS 1 LASER PRODUCT
The printer of this unit utilises a laser. Use
of controls or adjustments or performance
of procedures other than those specified
herein may result in hazardous radiation
exposure.
Laser diode properties
Laser output : Max. 15 mW
Wavelength : 760 nm – 800 nm
Emission duration : Continuous
LED light
CLASS 1 LED PRODUCT
Do not view directly with optical
instruments.
LED light of CIS properties
LED radiation output : Max. 1 mW
Wavelength :
Red 630 nm typ.
Green 520 nm typ.
Blue 465 nm typ.
Emission duration : Continuous
Fuser unit
During or immediately after printing, the
fuser unit (A) gets hot. This is normal. Do
not touch the fuser unit.
Note:
RThe area near the output tray (B) may also get warm.
This is normal.
B
A
Toner cartridge and drum cartridge
RWhen replacing the toner cartridge or drum cartridge,
do not allow dust, water, or liquids to come in contact
with the drum. This may affect print quality.
RFor optimal performance, genuine Panasonic toner
cartridges and drum cartridges are recommended.
We cannot be responsible for problems that may be
caused by a non-Panasonic toner cartridge or drum
cartridge:
– Damage to the unit
– Poor print quality
– Improper operation
Toner cartridge
RDo not leave the toner cartridge out of the protective
bag for a long time. It will decrease the toner life.
Drum cartridge
RRead the instructions on page 10 before you begin
installation of the drum cartridge. After you have read
them, open the drum cartridge protective bag. The
drum cartridge contains a photosensitive drum.
Exposing it to light may damage the drum. Once you
have opened the protective bag:
– Do not expose the drum cartridge to light for more
than 5 minutes.
– Do not touch or scratch the black drum surface.
– Do not place the drum cartridge near dust or dirt,
or in a high humidity area.
– Do not expose the drum cartridge to direct
sunlight.
RTo extend the life of the drum cartridge, the power
switch should never be turned OFF immediately after
3