2 Making/Answering Calls
Section 2
2-A Making Calls
(TALK) and
Indicator
(REDIAL)
(LOUD)
(CH) 
1Press≥The TALK indicator lights. ≥If an alarm tone sounds, see
2 | Dial a phone number. |
3 | To hang up, |
press (TALK) or place the |
handset on the base unit.
≥The indicator light goes out.
≥For best operating performance, see section
≥When dialling additional numbers after speed dialling [eg, AUTO
Otherwise, the unit may not dial correctly.
To redial the last number dialled
Press (TALK) 
(REDIAL).
To select the handset receiver volume
Press (LOUD) while talking. ≥Each time you press the button, the volume level will change from LOW
(preset) to HIGH.
If noise interferes with the conversation
Press (CH) to select a clearer channel or move closer to the base unit.
Backlit handset keypad
The handset dialling buttons will light when you press a button or lift the handset off the base unit, or when a call is received. The lights will go out a few seconds after pressing a button, lifting the handset or answering a call.
2-B Answering Calls
(TALK) and Indicator
(RINGER)
If the handset is off the base unit,
press | (TALK). |
|
≥You can also answer a call by pressing | ||
any dialling button | (0) to (9), ($) or | |
(— | Any Key Talk | ). |
OR
If on the base unit, just lift up.
Selecting the ringer volume
The TALK indicator light must be off.
≥To select HIGH (preset) or LOW, press (RINGER).
Each time you press the button, the ringer volume will change and the selected volume will ring.
≥To turn the ringer OFF,
press and hold (RINGER) until a beep sounds.
≥To turn the ringer ON,
press (RINGER).
For New Zealand Users Only:Additional Security Feature
In the event that a call cannot be made from the handset following a power interruption, disconnect the base unit from the line momentarily then reconnect it. Turn the handset off, and replace it on the base unit.
This will
