Panasonic KX-TG1850ALT operating instructions Sending a message, Writing and sending a new message

TG1850AL(e).book Page 36 Monday, December 6, 2004 9:10 PM

SMS (Short Message Service)

3Select “Public”, then press ,.

4Select “Settings”, then press ,.

5Enter “0000” (default base unit PIN). LIf you changed the PIN, enter it (page

30).

6Select “Message Centre1” or “Message Centre2”, then press

,.

7Edit the number as necessary, then press ,2 times.

8Press {ih}.

Note:

LIf your phone is connected to a PBX, you need to add the PBX line access number and a dialling pause to the beginning of the Message Centre 1 phone number.

Sending a message

Writing and sending a new message

1Press $(middle soft key).

2Select X, then press ,.

3To access the public mailbox Select “Public”, then press ,.

To access a private mailbox

Select the desired mailbox, press ,, then enter its password.

4Select “Create”, then press ,.

LIf “^Use Last Text?” is displayed, you can use the text from the last message you created by pressing {e}. This message will be displayed only if the last message was created using the same mailbox you selected in step 3.

5Enter the message (page 41), then press ,.

6Enter the destination phone number (20 digits max.), then press ,.

LTo send the message to a party saved in the phonebook, press U, select the phonebook entry, then press , 2 times.

LTo send the message to a party logged in the caller list, press {e} or {v} repeatedly to select the party, then press ,2 times.

LTo send the message to a phone number logged in the redial list, press qrepeatedly to select the phone number, then press ,2 times.

LIf you wish to send the message to the other party’s mailbox, enter the other party’s mailbox number after the destination phone number.

Example: The other party’s phone number is 123456 and their mailbox number is 1.

Enter 1234561.

If you do not enter the other party’s mailbox number, the message will be sent to the public mailbox.

7To save the message, select “Yes”, then press ,.

LTo send the message without saving it, select “No”, then press ,.

8To send the message, select “Send”, then press ,.

LTo cancel sending, press {ih}.

Note:

LThis unit supports SMS messages of up to 612 characters, however, the maximum number of characters you can send or receive may be limited by your SMS service provider. Consult your SMS service provider for details.

LIf your message contains over 160 characters, the message is a long message and j is displayed. Your service provider may treat long messages differently from other messages. Consult your service provider for details.

36