Panasonic KX-TG2302 operating instructions Getting Started, Accessories, Settings

1Getting Started

1-A Accessories 1-B Location of Controls

Section 1

AC Adaptor	one
Order No.
PQLV1Z
(PQLV1)
Telephone Line Cord	one
Order No.
PQJA10075Z

Handset

Back side

Speaker

Antenna

Base unit

Antenna (4-F)

CHARGE Indicator (1-C)

Battery	one
Order No.
HHR-P104
Handset Cover	one
Order No.
PQKK10140Z2
Belt Clip	one
Order No.
PQKE10375Z2
Shoulder Rest Attachment	one
Order No.
PQKE10364Z1

TALK Indicator			Charge
			Contacts (4-A)
(2-A, 2-B)		Receiver
[	] (TALK)	RECHARGE
Button (2-A)		Indicator (4-A)
[SP-PHONE]		[OFF] Button (2-A)
(Speakerphone) Button		[REDIAL]
(2-A)		Button (2-A)
Headset Jack (4-D)		VOL. (VOLUME) Key
		([▼], [▲]) (2-A, 2-B)
[	] (TONE)
Button (3-B)		[VOICE ENHANCER]
			IN USE Indicator
[FLASH/CALL WAIT]		Button and Indicator
		(1-C, 2-A)	(2-B, 3-A)
Button (3-C, 3-D)

For extra orders, call 1-800-332-5368.	Microphone (2-A)	[HANDSET LOCATOR] Button (3-A)
For hearing or speech impaired TTY	Charge Contacts (4-A)
users, call 1-866-605-1277.

1-C Settings

1	Connect as shown.
	Fasten the AC adaptor	Single-Line Telephone Jack (RJ11C)
	cord.	Telephone Line
	Hooks
		Cord	Power Outlet
			(AC 120 V, 60 Hz)
			AC
			Adaptor

2Insert the battery (#), and press it down until it snaps into the compartment ($).

Close the cover.

1 2

	To replace the battery:
• USE ONLY WITH Panasonic AC ADAPTOR PQLV1 (Order No. PQLV1Z).	Press the notch on the cover firmly and
	slide it as indicated by the arrow.
• The AC adaptor must remain connected at all times. (It is normal
	Replace the old battery with a new one
for the adaptor to feel warm during use.)
	(4-A). Close the cover and charge the
• The unit will not work during a power failure. We recommend
	battery for 6 hours.
connecting a standard telephone to the same telephone line or to
the same telephone jack using the Panasonic KX-J66 T-adaptor.	Charge the battery for 6 hours.
To select the dialing mode TONE (preset) or PULSE	STOP 3 • See section 4-A for more
Make sure the handset and base unit are not being used. The handset	details.
	• The unit beeps once and
must be operated near the base unit and while off the base unit.		OR
	the CHARGE indicator
1. Press [VOICE ENHANCER], then press [8].
	lights.
• The VOICE ENHANCER indicator flashes.
2. To select PULSE, press [1].
OR
To select TONE, press [2].
3. Press [VOICE ENHANCER].
• The handset beeps and the indicator light goes out.	CHARGE Indicator
For assistance, please call: 1-800-211-PANA(7262)