TG341xBX(e).book Page 22 Thursday, March 3, 2011 1:47 PM
Useful Information
Error messages
Display message | Cause/solution |
Busy | L The called handset is in use.*1 |
| L Another handset is in use and the system is busy. Try |
| again later.*1 |
| L The handset you are using is too far from the base |
| unit. Move closer and try again. |
No link | L The handset has lost communication with the base |
| unit. Move closer to the base unit and try again. |
| L Unplug the base unit’s AC adaptor to reset the unit. |
| Reconnect the adaptor and try again. |
| L The handset’s registration may have been canceled. |
| |
*1 |
|
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s AC adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset, and then insert the batteries into the handset again.
General use
Problem | Cause/solution |
The handset does not turn on | L Place the handset on the base unit or charger to turn on |
even after installing charged | the handset. |
batteries. |
|
The unit does not work. | L Make sure the batteries are installed correctly (page 8). |
| L Fully charge the batteries (page 9). |
| L Check the connections (page 8). |
| L Unplug the base unit’s AC adaptor to reset the unit. |
| Reconnect the adaptor and try again. |
| L The handset has not been registered to the base unit. |
| Register the handset (page 24). |
I cannot hear a dial tone. | L The base unit’s AC adaptor or telephone line cord is not |
| connected. Check the connections. |
| L Disconnect the base unit from the telephone line and |
| connect the line to a known working telephone. If the |
| working telephone operates properly, contact our service |
| personnel to have the unit repaired. If the working |
| telephone does not operate properly, contact your service |
| provider/telephone company. |
22
